where is shift selanoid B in the transmission. my stall wont lock up, it threw the code for that selanoid, and it wont go into overdrive, it would be nice to change it if i knew where it was.
by the way, what does it look like?
thanks for the help.

 

The shift solinoids are the two black ones towards rear of trans , they are identical , i ussually suggest changing them as a pair , question what was the number of the code you got ?

 

Here is a picture of a valve body with a vac mod set up. On the bottom of this photo there are two solenoids that look the same. These are the solenoids that you will need to replace. I would replace them both of them at the same time. If you need them go to our web page and send us a email or give us a call. Vince

 

this is what my diablo said

P0756 Shift soleniod B, Performance or stuck off

 

That is and indicator of a bad solinoid and replacing it would be a good first step but that code is actually set when the solinod is comanded on or off and the manifold sensor doent send the right signal back to the pcm , So though it is likley the solinoid there are a couple other possibilites also ,
stuck shift valve
bad switch in manifold sensor
But again its most likley the solinoid and as i said and vince repeated replace them as a set ,
I wish I know how to post pictures someone needs to show me sometime !

 

thanks guys, i really appreaciate the advice and info on this subject. if this fexes the problem i will respond to this thread again

THANKS!!!

 

fixes*

 

I did not repeat what you said. I was just busy uploading pictures and you beat me to it!!!LOL By the way guy's the part that you want to replace is spelled solenoid.

 

lol. yea well i got the point across

 

Yea well im not the best at spelling sometimes and unlike my ms word no spell check here , and I still dont know how to upload pictures but I will figure that out soon , lol

 

If I remeber right, they are about $25 each at the dealer. Just be careful when you pull the clip off them and take them out.......
One is OK, and will come right out, but the other has a spring loaded valve with a check ball in it. I know this cuz I was chasing them down the driveway after they flew out of the valve body.

 

true lol

 

 

Vince, what do these run price wise?

 

I'm a little confused to what your question is. Are you asking about the shift solenoids,trans, vac-mod....etc. I believe there is pricing on our web page for all the solenoids w/harness. If you need just the solenoids send us an email or give us a call and I will get you a price.Vince

 

Does this help:

 

cool thank you much , its may be a handy trick to know , sometimes its alot easier to show than explain

 

<hijack>
Is that PSA metal instead of plastic...?
</hijack>

 

in that pic which one would be the 2-3 solenoid??

 

Do you have a converter in your car? If so, if you let the car sit for a while, does the vehicle shift and lock up normal?