Converting non-PWM to PWM?
#22
Teching In
Join Date: Oct 2010
Location: Springfied, MO
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Are those two solenoids the same part #? I have a NON-PWM 4L80E that I want to run behind my LQ9 engine and PCM and am trying to figure out how to make it work. From what I've been able to gether if I pick up the PWM solenoid and a 95+ internal wiring harness I should be all set?
Is there a different way to go about making this work?
Is there a different way to go about making this work?
#24
Teching In
Join Date: Oct 2010
Location: Springfied, MO
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I guess what I meant to ask is in a 95+ 4L80E there are two PWM/TCC solenoid, right? Are those two the same? And are they also the same as the one solenoid found in a pre '95 80E?
#26
Teching In
Join Date: Oct 2010
Location: Springfied, MO
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Well, now I am confused. I contacted psiconversions about making a standalone harness for my LQ9 with a 4L80E, and they informed me that would be no problem so long as my 80E was '95 or newer because that's when GM switched to PWM. All the research that I've done supports this, and you're the first person that has said otherwise?
#27
Gingervitis Addict ![](http://s24.postimg.org/5ong4sl1t/Gingervitis2.jpg)
![](http://s24.postimg.org/5ong4sl1t/Gingervitis2.jpg)
iTrader: (2)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Well, now I am confused. I contacted psiconversions about making a standalone harness for my LQ9 with a 4L80E, and they informed me that would be no problem so long as my 80E was '95 or newer because that's when GM switched to PWM. All the research that I've done supports this, and you're the first person that has said otherwise?
#29
Moderator
iTrader: (1)
Join Date: Sep 2005
Location: Bloomingdale Illinois
Posts: 8,633
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
You will be fine with what you have for the external harness connector. The first couple of years there was a different case connector plug that was used but what you have with your trans is still being used today. HTH Vince
#31
9 Second Club
iTrader: (11)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I spent hours and hours looking for this info!!! THis should be a sticky! I have found a lot of info saying i cannot use my 94 4l60E and stall with my ls1 swap due to the pwm issues. This is a free fix for me and i can infact use it! THANKS PERFORMABUILT!! PS Thanks for also confirming this info over the phone as well!