REVSHIFT Rear Cradle Busings
11-20-2012, 02:51 AM
#1
TECH Enthusiast
Thread Starter
Join Date: Jun 2011
Location: New Haven, CT
Posts: 654
Likes: 0
Received 0 Likes
on
0 Posts
REVSHIFT Rear Cradle Busings Anybody have experience with these?
https://www.revshift.com/shop/rear-c...llac-cts-v.php
Better than the BMR?
https://www.revshift.com/shop/rear-c...llac-cts-v.php
Better than the BMR?
11-20-2012, 06:09 AM
#3
How do you get the old bushings out and the new bushings in? Do you need to press them out? It looks like the new ones are 2 piece so it should not be that bad going back in.
11-20-2012, 07:39 AM
#7
On The Tree
iTrader: (1)
Join Date: Mar 2012
Location: Northern VA
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
I saw that they are claiming that these eliminate wheel hop. I hope they do, but given how nothing seems to be able to eliminate it in the V1, I’m not holding my breath.
Trending Topics
11-20-2012, 09:08 AM
#11
lol truth, let us know how bad the install is.
oh when your Cs kit comes in can you take a pic of the DS center Carrier support, i wanna see if they redesigned it yet
11-20-2012, 10:12 AM
#12
On The Tree
Join Date: Aug 2011
Location: Brandon, ms
Posts: 140
Likes: 0
Received 0 Likes
on
0 Posts
I only have Internet on my phone, and that's a hassle. If you want to pm me a Phone #, l'll text em to you. I've already received the driveshaft.
Last edited by Sweetwilliebrownjr; 11-20-2012 at 10:21 AM.
11-20-2012, 11:10 AM
#13
TECH Enthusiast
Thread Starter
Join Date: Jun 2011
Location: New Haven, CT
Posts: 654
Likes: 0
Received 0 Likes
on
0 Posts
Haha, well guess I was jumping the gun! Good stuff, I like revshift, I'm running their motor mounts and trans mount. Looks like they are giving creative steel a run for their money! Can't wait to hear some feedback on how these work and how the install goes, I'm def in but not ready to be the first one on board!
Love Revshift prices the best!
Love Revshift prices the best!
11-20-2012, 07:21 PM
#17
I'm not trying to be a dick, but I cannot hold my tongue (or in this particular case fingers). But seriously? Did you even read through the thread? These were released to the public and put online last night. So if you had the install details, you would be revshift. 
11-20-2012, 08:15 PM
#19
install looks like a two piece bushing that you may not have to press in. You may be able to use washers and a bolt to tighten it up and press them in that way. However I believe you will need to use a press to get the stock bushings out. Someone feel free to chime in as I may be incorrect.