86 Trans Am project
#35
you can use any 2-3bar map sensor. i talk to msd about it and just bought one from summit. you might have to redo the connector but it will work just make sure you wire it the same 1 2 3.
#39
Alright, heads came out of the shop today, they had to go .010 just to clean them up, but it looks like a 7.4 PR should still the the ticket. Installed the heads and oil pan, strapped everything down, cannot install my intake because it is in the 95 Z28 we swapped the 6.0 into and my 1 inch set back adapter plates are as well, so i need to order another set of those so i can start the install.
You can see the weld repair from my free cracked oil pan:
You can see the weld repair from my free cracked oil pan: