When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Installed my Kooks 1 7/8 Stainless Steel Headers and Catted High Flow Y-Pipe this weekend....
For everyone that does this Without a Lift- My Hats off to you!! I had the privilege of using a good friends lift and air tools. I'm not sure I would have attempted it without one. I salute everyone that's done this off the floor with jack stands!!
Installed my Kooks 1 7/8 Stainless Steel Headers and Catted High Flow Y-Pipe this weekend....
For everyone that does this Without a Lift- My Hats off to you!! I had the privilege of using a good friends lift and air tools. I'm not sure I would have attempted it without one. I salute everyone that's done this off the floor with jack stands!!
Scotty- Absolutely sir!! I just posted a few pictures & short description in my build thread. Later today I'll be doing a full review write-up, along with pictures in the External Engine Bolt-On section.
I'll attempt to take and upload my first video of the sound... But I'm betting it doesn't sound near as good as yours....
Drove "Davin" into work today.... Getting the ol' car retuned after work for the installation of my LT's. Wonder how much, if any, difference I'll notice?!?!
Bought Long tubes, ORY and LM II catback last week. Still waiting to install them. I washed it this morning though.... It needed it bad. I was out if town for a week and it got rained on and dusted on so it had some nasty dirt spots everywhere. Looked horrible on my pristine white paint... Totally forgot about the car cover... Wish I had a garage!!!!
Drove mine for a couple hours last night while we did some data logging and tuning since installing the Kooks LT Headers. Seems to run much better now.... I still have to work on getting that video.....
Got it ready for the shippers this week and found out I had a screw in one of my back tires. Got that patched, I guess it's time to order new backs though...
Got a free Panel, so I decided to do the Berger panel mod! Didn't want to mess the old one up because it was so nice, so I painted the free one. Of course I then ran over the corner of my nice one since I forgot I laid it in the f***ing garage beside the car....
Got a free Panel, so I decided to do the Berger panel mod! Didn't want to mess the old one up because it was so nice, so I painted the free one. Of course I then ran over the corner of my nice one since I forgot I laid it in the f***ing garage beside the car....
That be suck! But the new one looks great so all's well that ends well!
....and in case you think you get good quality control and customer service when you spend good money on wheels, think again. Boxes in perfect condition. Both rear wheels looked like this...
Been waiting months for Weld to get me 2 good wheels.
08-10-2015, 10:24 AM
Get Kook'n with Kooks 
