tsnow678

iTrader: (3)

Matt could you tell me who made your driveshaft? I looked back and did not see any information concerning it. What material did you have it made out of? Any information you could send my way would be greatly appreciated.

c6matt

iTrader: (1)

fort wane drivline and clutch, I'll look for a link. I told them my measurements and toll them my HP and they built me a shaft to hold it. had 3 shafts made by them for diffrent projects.. a+ company..

Got the vette out today for about 40 miles..

tsnow678

iTrader: (3)

Sweet ride!!! A friend of mine had a Vette similar and it was awesome. You just dont see that many old Vettes any more cruising down the road. They are a head turner for sure!!

Thanks for the info.

bmf5150

Very nice car Matt!!

66vert

iTrader: (3)

clean looking vette

c6matt

iTrader: (1)

Just ordered the "body kit" - a rust free northern car!
Black Viny Roof
Full door R
Full door L
L quarter
R quarter
front fender L
front fender R
Outer Rocker L
Outer Rocker R
Deck filler Panel
outer wheel house L
outer wheel house r
inner Rocker L
inner Rocker R
Inner wheel house L
Inner wheel house R
Trunk floor
Gas Cap

c6matt

iTrader: (1)

http://www.fortwayneclutch.com/

tsnow678

iTrader: (3)

Thanks! I will definitely give them a call.

c6matt

iTrader: (1)

NPD Stock going up


Of course it had to rain..

-TheBandit-

iTrader: (1)

Geez man. That is going to be some major surgery. Wont be much left of her!

bonecrrusher

iTrader: (1)

Holycrap...

I think there will be paint jail in the future for you?

You going to the start of the HRPT?

c6matt

iTrader: (1)

I'll be long hauling. I should have the car back by labor day. So a little paint jail, but I'll have the vette and my dads 70 elcamino (lm7/4l60) for the summer. After PT he is taking my camaro to NY where my painter is. And when I got to get the camaro I'll drive his elcamino home.

Finally got around to picking up the rear seat, interior is done. It gets aligned this week.




Sheetmetal on its way to NY for the paint after PT...

bmf5150

Looking good Matt,seats sure look nice!

bonecrrusher

iTrader: (1)

That van part of the RV haul back home?

c6matt

iTrader: (1)

Yep, killed two birds with one van...

bonecrrusher

iTrader: (1)

I ran over a duck with a van once... crunched it with the rear half ton axle... lol.

c6matt

iTrader: (1)

I ran over a bird on a "track" at about 100 mph in a t56 equipped lt1 9C1 caprice... found the bird in the driverside caliper a week later... well... most of it.

bonecrrusher

iTrader: (1)

Caprice with a T56 - now that sounds fun...

This Impala SS - has a T56 too:


And a whole lot of nitrous in the trunk too...

c6matt

iTrader: (1)

too much work for a heavy lt1 car now.. I would of lusted after that bad circa 2003-2004. I was addicted to b-bodies

c6matt

iTrader: (1)

All ready for power tour... Dad is showing up tonight from NY in a 5.3 swapped 70 elcamino... Look for us on the road!