coolant steam tube?
coolant steam tube? where are you guys putting them?
I know with LT1's its popular to tie it into the upper radiator hose. Just wondering what you guys are doing with your LS swaps.
I know with LT1's its popular to tie it into the upper radiator hose. Just wondering what you guys are doing with your LS swaps.
Trending Topics
Car is a 92 firebird and the hose is for a 90 Ford F250 7.5L. I trimmed both ends to fit
The bung on the radiator is the ideal situation. If you have an alum radiator and access to a welder, its a great option. Same for people who go with the 4th gen radiators
The bung on the radiator is the ideal situation. If you have an alum radiator and access to a welder, its a great option. Same for people who go with the 4th gen radiators
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
On The Tree
Joined: Feb 2008
Posts: 110
Likes: 0
My radiator had a bung in it also so I followed the upper rad hose and a little channel between the rad and support to the bung fitting. It is good to get it to the highest point to make sure the air gets out of the engine.
TECH Senior Member
Joined: Jul 2009
Posts: 8,033
Likes: 661
steam vent Thats what I am going to do too. I plan on trying to epoxy some clips to hold the steam on the bottom of either the upper hose or intake tube. Going for invisable
