Jimbo1367

Looking good. How many miles do you have on the gears? Quiet? What RPMs are you pulling at 55 MPH?

So I can only assume all the hard work was worth it with the new found power. Your thoughts or anything you with you did differently?

Thanks,
Jim

M6 Swap

iTrader: (1)

No miles on anything yet! Still hasn't seen the road with the new powertrain. Need 2 finish up the brakes and get the driveshaft redone then I should be able 2 put around town and work out the kinks

M6 Swap

iTrader: (1)

Got the new brake lines built and hooked up to the adjustable proportioning valve.

M6 Swap

iTrader: (1)

Decided to swap the front end to the split bumper 70 RS

M6 Swap

iTrader: (1)

installed AN fittings on transmission to run braided hose to the cooler


also started mocking up the seat tracks for the 04 GTO seats

M6 Swap

iTrader: (1)

Trans cooler and lines installed

ls1jorge

iTrader: (5)

nice bro car looks good!

I parted away with my 79 Camaro a few weeks back but I wanna get me another 2nd gen

70-73

M6 Swap

iTrader: (1)

The first test drive is in the books, hope to get the exhaust done in the coming weeks and take it on some more

wesguin

so are you bypassing the return on the fuel pump with one line? and what fuel filter did you use with this setup

rjb2968

What headers did you end up using?

M6 Swap

iTrader: (1)

I used the VetteWorks fuel pump kit, look at page 16 for more info and pics. Summit Racing fuel filter -6AN fittings on both ends.

M6 Swap

iTrader: (1)

Ended up sticking with the 2000 F body manifolds. They fit better than the 2010's. Still haven't had the exhaust run to the back but when I do I will post up some pics and a vid

wesguin

where did you mount your PCM

M6 Swap

iTrader: (1)

Behind the dash just above the trans tunnel

M6 Swap

iTrader: (1)

just picked up a set of hooker headers off CL.

Jimbo1367

Looking good. I was glad to see you update this. Holley could of made the primary tubes look ALOT better than they did IMHO. But they fit pretty tight by the looks of it. +

M6 Swap

iTrader: (1)

drivers side hangs lower than I would like but if they sound like I think they will its worth it!

Jimbo1367

Did you ever get a exhaust done and do your maiden vouyage yet?

M6 Swap

iTrader: (1)

not yet, had to reroute the trans cooler lines and starter wire but now that's done so hopefully soon.

SSZ

How do u like the GTO seats?
Any pics?
I have a set in my 80 Z28. I like them but good for tall people. Very comfy though.