Help Asap!
Help Asap! ok i have a 99 ls1 motor with a 01 t 56 i just put a new slave cylinder in and a new master and the dam thing wont go in to gear and if i start it in gear the cluch doesnt disingauge so it keep s moving untill it dies? i had the tranny out for the second time any one no what my problem could be .?????????
No Clutch? Hey, are you sure you bled all the air out? Is your clutch pedal nice and firm thruogh the full range of travel from the top to the floor? One way you can tell if theres still air is to pump the pedal 5-10 times and see if it will go into gear and then when you release the pedal you will probably have to pump it up again. 
Trending Topics
There's a procedure for using a Mity-Vac to pull the air from the master cyl, basically just fill the clutch reservoir w/ fluid, use the conical tip on the Mity-Vac seated into the hole at the bottom of the reservoir, pull a vacuum, then quickly remove the cone so that the vacuum you created is backfilled w/ fluid from the reservoir.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
