fenderwell mounted pcm cover
#1
Teching In
Thread Starter
Join Date: Jun 2005
Location: Omaha Ne
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
fenderwell mounted pcm cover
I'm want to mount my pcm on the passenger side fenderwell of my 66 Nova. Does anyone know of a cover/mount made that will work and look good? It looks like alot of the pcm's are mounted inside of the cars, but my harness is not long enough plus with the vintage air added it will not have room under the dash. My ls1 is from a 2001 z28
#2
TECH Senior Member
iTrader: (7)
I am not aware of any covers, but I lengthened my harness and mounted the PCM inside the car. Snip.....solder...solder...snip....solder...solder ...snip...solder....solder....X60....Sheesh!
Andrew
Andrew
#4
sawzall wielding director
iTrader: (4)
It is water proof and the PCM is mounted in the engine compartment in most LSx vehicles. There is a cover on the 2001 Tahoe computer mount. I am not using it in my conversion (I like the bare computer, makes it look high tech ) . But I will put the cover on tomorrow and snap a pic and post it.
#5
TECH Enthusiast
iTrader: (6)
Originally Posted by Project GatTagO
I am not aware of any covers, but I lengthened my harness and mounted the PCM inside the car. Snip.....solder...solder...snip....solder...solder ...snip...solder....solder....X60....Sheesh!
Andrew
Andrew
my pcm is in the engine bay. I made a plate onto which it sits
#6
sawzall wielding director
iTrader: (4)
Originally Posted by Schitzo
you my friend are a patient man.....I was going to do this but after modding my harness and rewiring my entire car, I was done soldering for a while.....
my pcm is in the engine bay. I made a plate onto which it sits
my pcm is in the engine bay. I made a plate onto which it sits