LQ4 into a 3rd Gen/1972 Nova
#1282
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I took that pic at 11:30 last night! Saturday I plan to put a permit on it, get it emissions tested, and [hopefully] put plates back on it for the first time since Oct 2006. Geez I didn't realize how long this has taken until I just typed that date....
#1289
TECH Senior Member
iTrader: (12)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
To bad us Nova guys are not in one or a closer region.. would be great to get the cars together.. !
I know Pleasanton is having a Nova Mini Nat's Labor Day weekend.. ! If I don't go out of town. I will drop in.. many of the Steve's Nova Sites guys will be there..
BC
I know Pleasanton is having a Nova Mini Nat's Labor Day weekend.. ! If I don't go out of town. I will drop in.. many of the Steve's Nova Sites guys will be there..
BC
#1290
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
On the ground, ready to drive. Except.. the ******* thing won't fire. Cranks forever, gets good fuel pressure, proper injector pulse, MAP sensor reads maxed out. I have a hard time believing the MAP sensor went screwy since the last time I drive it and it was working fine. Going to go hunting for grounds, but this goddamn thing is really starting to **** me off. Could also be a bad PCM since I'm not getting a MIL light, tach, or speedo outputs from the PCM.
![](https://ls1tech.com/forums/attachments/conversions-swaps/405531d1370539470-lq4-into-3rd-gen-1972-nova-wp_20130605_010.jpg)
#1293
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I had the same thing happen to me once...I had a wire that chaffed that was causing the car to not start all the time...and I had one wire that was loose in a crimp connector that would cause the car to back fire...
#1295
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Only happened once. Was driving, **** went super rich, turned it off. HPtuners scanner confirmed injectors were flowing high because MAP reading was 193kpa. Did a Reflash Write and it was fine after. Now, despite Quick Write or Write Entire, it still reads maxed MAP pressure. With the MAP sensor disconnected it reads 90kpa. Something has always been suspect with the setup because none of my gauges that are hooked up to the PCM pin outs read anything. MIL light test doesnt work, speedo doesn't work, tach doesn't work. In HPtuners tho, tach/speedo read and display accurately. I wonder if there's some circuit that at some point got fried and it's contributing to a spotty ground for the MAP sensor as well as not letting the gauge outputs work. *****.
#1297
11 Second Club
Join Date: Mar 2008
Location: New Westminster, B.C., Canada
Posts: 445
Likes: 0
Received 1 Like
on
1 Post
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Check your input voltage to your map sensor. It should be 5v. If it isn't, say its higher, it could be a bad Zener diode or you have a gauge that is putting battery voltage back through your sensor source circuit. If it keeps going max map that would indicate a high voltage output from that sensor (5v or higher). Come drink with me tomorrow night and we'll trouble shoot it Saturday.