Cam only LT1
12-11-2006, 10:17 AM
#1
11 Second Club
Thread Starter
Join Date: Nov 2001
Location: Houma,La.
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
Cam only LT1 I ran the last race for this year at NPR. Air was about-800ft. I managed a slightly better 11.15 in the bracket race. Now on that run I was on the brakes so the speed was only low 118. On that run I had a 1.48 short time and ran 7.04 to the 1/8. As most of you know I run a stockhead Na Lt1 streetcar. Frank95z
12-11-2006, 10:50 AM
#4
11 Second Club
Thread Starter
Join Date: Nov 2001
Location: Houma,La.
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
More agressive than the regular off shelf cams that are usually mentioned here. But with a good tune it doesn't surge and idles well. With that said this cam was actually ground to compliment a set of ported heads that i haven't put on yet. But this ground seems to be killer with stockheads. Frank95z
12-11-2006, 01:25 PM
#5
TECH Addict
Join Date: Jul 2002
Location: Somewhere I Belong
Posts: 2,906
Likes: 0
Received 0 Likes
on
0 Posts
As always Very nice ET Frank & my buddy picked his Cammed LT1 putting down 342rwhp/360rwtq the car wieghing 3500lbs next step a Major weight ! 
Btw what is your rwhp/rwtq Frank ?!
peace
Btw what is your rwhp/rwtq Frank ?!
peace
12-11-2006, 04:56 PM
#6
11 Second Club
Thread Starter
Join Date: Nov 2001
Location: Houma,La.
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
Bad95killer I made 357rwhp 390rwtq thru a unlocked Vig3200/12bolt rear. That was with mufflers/belt on and only pulling to 6000. Valve springs were weak and graph was getting irregular. Frank95z
Trending Topics
12-13-2006, 07:17 PM
#8
10 Second Club
Join Date: Mar 2003
Location: pierre part louisiana
Posts: 346
Likes: 0
Received 0 Likes
on
0 Posts
congrats on you new time and the championship when you gonna put those heads on and get close to me
are you going to run NO E for the points this year?
are you going to run NO E for the points this year?
12-13-2006, 09:19 PM
#9
11 Second Club
Thread Starter
Join Date: Nov 2001
Location: Houma,La.
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
Red01chevy Elvin Hicks and I were supposed to assemble my heads and put them on this week(I need a lift to remove headers) When I called him he said that he was busy this week.He has been working on projects(newlywed). I would like to get it done and I may wind up bringing the car to a great shop in Pierre Part 
Think you know who I mean. I'm going to finish out the first half in Street then I'll make the choice. Frank95z
Think you know who I mean. I'm going to finish out the first half in Street then I'll make the choice. Frank95z 
