BoostedLQ9SS

iTrader: (11)

This guy does an awesome job of fitting these cages and making them look factory.

http://www.youtube.com/watch?v=781uSnS9Nb0

He is working on 2000 trans am in shop right now. 10 pt cage.


He not super fast but the work speaks for its self!

Ralph

BlackScreaminMachine

iTrader: (17)

No Youtube at work, any still pics?

My 04 Goat

Is that a mustang thing running a bar between the two rear down bars ?? Never seen that on a 6 point before..


Good work.. Fits real good

358chevycamaro

iTrader: (10)

I know of a local Camaro with an 8 point with said bar.

I'd hate to see the bill for that roll bar... lol

silverbeast

iTrader: (16)

that is very nice work....and i bet it was high too.

ty_ty13

iTrader: (42)

door bar sets to far out from the rocker panel where you feet are would be my only complaint.

Ericbigmac83

iTrader: (19)

That is a lot of work for a 6pt. ouch.

Side note, saw Metallica two weekends ago, what a good show

BoostedLQ9SS

iTrader: (11)

That cage runs about $2500.00 installed in Chrome moly and about $2200.00 for mild steel tubing.

There actually is plent of room in by your legs, may look far in but for the support with the plate under the floor.

My Malibu Project will be getting 6pt Chrome moly from the same shop in month or So.

BoostedLQ9SS

tektrans

iTrader: (23)

Very nice work.