408 ms4 243's dyno numbers
#1
TECH Apprentice
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: Newberg Oregon
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
408 ms4 243's dyno numbers
(from a previous post) Ran my car today with 408, ms4, stage 1 243's stock ls6 intake,basic bolt ons on a m6 through stock 10 bolt and i ran this on a mustang dyno and made 470 hp and 440 ft lbs. I ran out of injector on the top , but it's got some power and im deffinatley happy
#3
LS1Tech Premium Sponsor
iTrader: (5)
Nice results for a 2.00"/1.55" valve head on a mustang dyno!
Got a graph by chance?
Got a graph by chance?
__________________
Largest Stocking Distributor of LS-x Engines / CHECK OUT OUR NEW WEBSITE!
COMP - FAST - PACESETTER - DIAMOND RACING - EAGLE SPECIALTY PRODUCTS - CALLIES - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - KOOK'S HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - AND MORE!
Largest Stocking Distributor of LS-x Engines / CHECK OUT OUR NEW WEBSITE!
COMP - FAST - PACESETTER - DIAMOND RACING - EAGLE SPECIALTY PRODUCTS - CALLIES - COMETIC GASKETS
RAM CLUTCHES - MOSER ENGINEERING - KOOK'S HEADERS - ARP - GM BOLTS AND GASKETS - MSD - NGK
POWERBOND - ASP - AND MORE!
#5
TECH Fanatic
iTrader: (4)
Join Date: Apr 2005
Location: Shelby twp, MI
Posts: 1,514
Likes: 0
Received 0 Likes
on
0 Posts
Very good numbers for the below average Top end you have! With a intake change I bet it would be close to 500RWHP. With a swap to some aftermarket casting heads with some big valves who knows that it could make!
Trending Topics
#11
TECH Apprentice
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: Newberg Oregon
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
Im running 3.42 rear gears and 1 7/8" headers. I know there is plenty on the table but i just have to save up money now, next comes a 9" after that fast 92/92 setup then nitrous and probably step up to trickflows. But first I need injectors it leaned out on top i will get the dyno sheet on here soon but here is a video to hold you off for now
http://www.youtube.com/watch?v=P2ihJznCpFA
http://www.youtube.com/watch?v=P2ihJznCpFA
#18
TECH Apprentice
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: Newberg Oregon
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
I ran a 12.0 friday which wasnt bad considering i was going easy on the stock 10 bolt and since it leans out up top. I have a dyno graph but cant figure out how to get it on here in the correct format
#20
Me too
I have a 402 with a ms4 1 3/4 headers and a fast 92 setup and made 492 hp 478 lbs torque! A better head alone say prc ls6 stg 2.5 or 3 would net you well over 500 with ease!!!! With a fast 92 even more ! Damn nice # !