me vs 03 pullied cobra vert
12-03-2009, 06:03 PM
#1
me vs 03 pullied cobra vert my buddy is pickin up an 03 cobra vert with a pulley intake exhaust and tune put down 460rwhp. i have mods in sig made 390 on a mustang dyno with the cutout closed and 415 hp on a dynojet i weighed my car with an 1/8 of tank and it was 3360 i dont know how much a convertable cobra weighs what are my odds?
12-03-2009, 10:50 PM
#2
Teching In
iTrader: (2)
Join Date: May 2007
Location: Socal
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
my buddy is pickin up an 03 cobra vert with a pulley intake exhaust and tune put down 460rwhp. i have mods in sig made 390 on a mustang dyno with the cutout closed and 415 hp on a dynojet i weighed my car with an 1/8 of tank and it was 3360 i dont know how much a convertable cobra weighs what are my odds?
12-03-2009, 11:40 PM
#6
11 Second Club
iTrader: (8)
Join Date: Jan 2002
Location: SILSBEE TX
Posts: 1,782
Likes: 0
Received 0 Likes
on
0 Posts
My son has a 03 vert weights 4k with him (160) puts down 460-480 rwh
with drag radials on both we run within .005 (which is about 1-3 ft)of each.he is 2-3 mph faster. NA I am a little slower, but out of 10 runs I will take most because I am more consistant,should be a good run( na I put down a little less than you, I am a4/stalled)
with drag radials on both we run within .005 (which is about 1-3 ft)of each.he is 2-3 mph faster. NA I am a little slower, but out of 10 runs I will take most because I am more consistant,should be a good run( na I put down a little less than you, I am a4/stalled)
12-03-2009, 11:41 PM
#7
My son has a 03 vert weights 4k with him (160) puts down 460-480 rwh
with drag radials on both we run within .005 (which is about 1-3 ft)of each.he is 2-3 mph faster. NA I am a little slower, but out of 10 runs I will take most because I am more consistant,should be a good run( na I put down a little less than you, I am a4/stalled)
with drag radials on both we run within .005 (which is about 1-3 ft)of each.he is 2-3 mph faster. NA I am a little slower, but out of 10 runs I will take most because I am more consistant,should be a good run( na I put down a little less than you, I am a4/stalled)
It takes a lot for a stalled a4 to run with a pullied Cobra.
Trending Topics
12-04-2009, 03:39 PM
#9
yea roll races and a few digs hes on mt's and im on 555r's i dead hook in 1st we weigh about the same were big boys 200lbs. yea its a new car but he can drive a stick but its his 1st rwd car he has a wrx im thinking it should be real close
12-04-2009, 04:46 PM
#10
TECH Apprentice
Join Date: Aug 2006
Location: CA
Posts: 335
Likes: 0
Received 0 Likes
on
0 Posts
knowing how to drive a stick has little to do with knowing how to drive that car.
12-05-2009, 08:07 AM
#12
TECH Enthusiast
iTrader: (4)
Join Date: Mar 2008
Location: NJ
Posts: 541
Likes: 0
Received 0 Likes
on
0 Posts
Your right. To the OP: your friend is used to AWD not RWD. You go from a dig, he better know how to control his back end IF it decides to sit sidewayz through a gear or two. BUT i will give you the benefit.
