matts02ws6

My friend is bveing this exact car in a few days..


http://stlouis.craigslist.org/cto/1868103236.html



I have an 02 ws6 with c-force clutch, Z06 flywheel, long tube headers, 85mm throttle body, smooth bellow slp, with k&n filter, torque arm bar and pan hard bars, all polyurethane bushings, tranny mount and motor mounts.


Alota internet sites say stock srt4 runs low 14 on the quarter mile? but i know NOTHING about them.

Funkster

iTrader: (97)

If you can drive you will crush it.

They are mid 14 cars with an average driver and those parts aren't going to do a lot for him. Not to mention that SRT-4s get crazy wheel hop and don't launch worth a damn.

No worries.

02TransAm/Batmobile

iTrader: (32)

I raced a modded SRT-4 before and crushed him. This was about 3 years ago and I forgot the modifications he mentioned but I remember taking note that it was a moderately modded SRT-4. It shot out some flames out of the rear too.

All I have done is a lid and an exhaust cut out at the time.

EW1

iTrader: (10)

Take him on.

TAtoad

iTrader: (22)

you'll take him dead stop. rolling those little suckers can be suprising.

PRND3L

It all depends on the SRT4s driver.

Funkster

iTrader: (97)

Ya, valid point.

I assumed from a dig but this gentleman is correct.

40+ Roll and it may be a different story.

Gaunt

iTrader: (11)

Give him the hit depending on where you race.

Don't want him to torque steer into your car

PRND3L

If it was a Caliber, yeah. Neons dont torque steer bad. Calibers are rediculous!

Gaunt

iTrader: (11)

Yeah, you are right on that. From what I understand, it isn't too hard to correct for the torque steer anyway, but going from that guys craigslist ad, it doesn't look like he has the suspension for it.