post up eps 234/246 and 236/248 results
#21
TECH Apprentice
Join Date: Jul 2006
Location: Kansas City
Posts: 301
Likes: 0
Received 0 Likes
on
0 Posts
#22
11 Second Club
iTrader: (2)
https://ls1tech.com/forums/generatio...low-power.html
#24
On The Tree
iTrader: (3)
Join Date: Jul 2009
Location: louisiana
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Well swapped the new cam in and made it to the dyno. Weather was way worse than the last time on it and the car actually made 6 less horsepower. Fealt stronger on the street though, brought it to the track this past sunday and the car trapped 131.8. Im pretty happy, picked up a solid 3mph from just a cam change. Cars an absolute animal from 4k-7k
#26
TECH Fanatic
iTrader: (2)
still no numbers from me, though this is what my current setup is
84 RX7
forged 378 LS3
806 heads with 2.02/1.6 valves lots of porting
super victor
12.28 compression
T56 with monster stage 4
8.8 rear with 3.73 gears
2" longtubes dual 3" exhaust
car is 2740 with me in it and fuel
Anyway I have just gotten it going and its a bitch to run hard, hits the limiter at 6800 so fast its hard to tell whats going on. Once its tuned in again and I can shift it at 7500 it will be basically scary as ****. I put 8-10 cars on a new LS3 Camaro the other day from 65-130 while burning the tires in 3rd gear. Best cam ever for this setup it is almost undriveable from 4500rpm and never stops pulling clear up to 7500
84 RX7
forged 378 LS3
806 heads with 2.02/1.6 valves lots of porting
super victor
12.28 compression
T56 with monster stage 4
8.8 rear with 3.73 gears
2" longtubes dual 3" exhaust
car is 2740 with me in it and fuel
Anyway I have just gotten it going and its a bitch to run hard, hits the limiter at 6800 so fast its hard to tell whats going on. Once its tuned in again and I can shift it at 7500 it will be basically scary as ****. I put 8-10 cars on a new LS3 Camaro the other day from 65-130 while burning the tires in 3rd gear. Best cam ever for this setup it is almost undriveable from 4500rpm and never stops pulling clear up to 7500
#29
thank you for updating this thread, just curious if any of you with the 236/248 had to flycut your pistons...i have a 236/248@.50 112+4 with 108icl just curious as to what to expect before i install and check my PTV clearances, thanks in advance