Hampton Roads...Another New One..
I've got pics on my pda... I don't think I have you guys' numbers or I'd just send you a couple pics...I can't figure out for the life of me how to post pics from this PDA.... If you go to performancetrucks.net and look in the projects section you will see my build thread... Pics of the kit are in there. it came out nice though... I coated the turbo manifold, driver manifold, and down pipe myself... And it came out nice, its held up to 1450deg EGTs a few times already hahaha.... Still tuning and figuring out a catch can though...
The kit is a custom front mounted MP T-70 turbo with .96 a/r exhaust housing... I went with a fresh in tank 255 pump and some 60# Siemens Decka injectors, which required some other mods to my fuel system. A rather large IC with 3" inlet and outlet (big enough I had to notch my trucks framerails to fit it lol)... 38mm Tial WG, and 50mm BOV, I put a cutout at the end of the DP. Custom charge piping, and 2 Bar OLSD tuning by me... I'm getting it slowly but surely. Its a pretty steep learning curve going from tuning basically nothing, to tuning a 2 bar OLSD F/I truck hahaha...
Its setup only on 6psi... But I've got a manual controller
Its setup only on 6psi... But I've got a manual controller
By law it fails, some places check some dont. When you come in with a vehicle with a rumbling exhaust most tend to look just out of curiousity. I dont have cats on either of my vehicles, but thats the perks of being an inspector.
Thread Starter
Joined: Aug 2002
Posts: 10,331
Likes: 1
From: San Antonio, TX
The kit is a custom front mounted MP T-70 turbo with .96 a/r exhaust housing... I went with a fresh in tank 255 pump and some 60# Siemens Decka injectors, which required some other mods to my fuel system. A rather large IC with 3" inlet and outlet (big enough I had to notch my trucks framerails to fit it lol)... 38mm Tial WG, and 50mm BOV, I put a cutout at the end of the DP. Custom charge piping, and 2 Bar OLSD tuning by me... I'm getting it slowly but surely. Its a pretty steep learning curve going from tuning basically nothing, to tuning a 2 bar OLSD F/I truck hahaha...
Its setup only on 6psi... But I've got a manual controller
Its setup only on 6psi... But I've got a manual controller
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Thread Starter
Joined: Aug 2002
Posts: 10,331
Likes: 1
From: San Antonio, TX
Saw This bad boy at the track last night..... In Memphis...
I snapped a few pic's with my iPhone. Sorry quality isnt better.
On stock tires with 1000 miles on it..... 11.25@131 isnt bad at all.
He did better then Road and Track.
This was his best pass of 6 passes.... started out @ 11.6 then 11.4...
I looked at the slip and it went like this
60' - 1.967
1/8 - 7.45@101.97
1/4 - 11.25@131.3
Here are the pic's....
Anyone else seen them in person yet???
Kyle
I snapped a few pic's with my iPhone. Sorry quality isnt better.
On stock tires with 1000 miles on it..... 11.25@131 isnt bad at all.
He did better then Road and Track.
This was his best pass of 6 passes.... started out @ 11.6 then 11.4...
I looked at the slip and it went like this
60' - 1.967
1/8 - 7.45@101.97
1/4 - 11.25@131.3
Here are the pic's....
Anyone else seen them in person yet???
Kyle
