My KYTP GT47-88 Manifold kit
#1
TECH Enthusiast
Thread Starter
iTrader: (10)
Join Date: Dec 2006
Location: Edmonton, CANADA
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
My KYTP GT47-88 Manifold kit
Josh has been workin on this for a while, got it a few weeks ago and just got it back from the coaters, very happy with the work! Thanks Josh! these pictures don't do it justice!
Last edited by Sweet71; 03-13-2010 at 12:39 PM.
Trending Topics
#10
TECH Junkie
iTrader: (71)
Join Date: Mar 2002
Location: East Brady, Pa
Posts: 3,703
Likes: 0
Received 0 Likes
on
0 Posts
Looks great. Is that for a BMR turbo K member? What radiator setup do you plan to run? Judging from the front of the motor it's going to be very tight. Can't wait to see some installed pics.
#11
TECH Enthusiast
Thread Starter
iTrader: (10)
Join Date: Dec 2006
Location: Edmonton, CANADA
Posts: 515
Likes: 0
Received 0 Likes
on
0 Posts
Ya its a BMR turbo k member, the rad is the 27.5 x15.5 griffin, the compressor housing is about an inch into the core support, the front of the rad will lean forward. Have not fit everything yet, im sure it will be a pain in the *** though!
#16
The setup is no doubt gonna be tight. Both with the Radiator and 4" DP.
The BMR k-member gives you alot of room but hammer work or channeling onf the DP is a required bit of evil.
Enjoy it bro. Should make some killer power.
The BMR k-member gives you alot of room but hammer work or channeling onf the DP is a required bit of evil.
Enjoy it bro. Should make some killer power.
#20
TECH Fanatic
iTrader: (4)
Join Date: Mar 2004
Location: San Antonio
Posts: 1,886
Likes: 0
Received 0 Likes
on
0 Posts
It makes me wonder how much different my kit will be. I plan on having all of the hot side coated professionally and adding a blanket to it. And maybe exhaust wrap