3" OBX v-band dimensions
03-15-2011, 10:51 AM
#1
TECH Apprentice
Thread Starter
iTrader: (16)
Join Date: Feb 2008
Location: Fort Wayne, IN
Posts: 363
Likes: 0
Received 0 Likes
on
0 Posts
3" OBX v-band dimensions I need the ID and OD dimensions to make sure it will fit my Precision 6265s. The V-band inlet was an odd ball size that only Precision makes (and charges a small fortune for) so I'm hoping the outlet isn't the same way...
03-15-2011, 01:30 PM
#4
9 Second Club
iTrader: (6)
Join Date: Aug 2002
Location: Cecil County, MD
Posts: 886
Likes: 0
Received 0 Likes
on
0 Posts
I have a set of 3" in the shop, I'll look and see if they fit my turbine housings on the 6265s. From memory I think they are too small. a 3.5" might work.
Frank
Frank
Trending Topics
03-28-2011, 07:40 PM
#9
9 Second Club
iTrader: (6)
Join Date: Aug 2002
Location: Cecil County, MD
Posts: 886
Likes: 0
Received 0 Likes
on
0 Posts
OK, just picked up my 6765's and flanges today. I compared the precision flanges to the obx for ya. They won't work at all. Not only are they smaller both id and od in diameter they are thinner so the clamp wouldn't fit. Here are some pix.
OBX on the right, Precision on Left
OBX on the right, Precision on Left
