Finally got the SS to the dyno for some numbers :)
Finally got the SS to the dyno for some numbers :) I finally was able to get the car to the dyno yesterday to get some confirmed numbers. Very satisfied with the end results 
Trending Topics
Single Aero 340 in tank, Racetronix hot-wire kit, stock lines and regulator, FAST rails and Seimens Deka 60's. This winter going to be upgrading pretty much all of that
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Yup for the most part. It's an 02 with the LS6 block, stock 241 heads, rods, pistons, and crank. ARP hardware throughout and all the necessary cam upgrade parts.
Fully forged engine in the works to be swapped in at some point.
Fully forged engine in the works to be swapped in at some point.
I should add the car has been at this power level for about 2 full seasons now. I don't drive the car a ton, nice weather only, car cruises and meets and a car show here and there but when I do get it out it always gets played with and beat on LOL.
Thanks a ton guys much appreciated! No pics right now but I can grab some if you want. The first nozzle is about 8" or so from the TB and the second it about another 6" from the first.
12 Second Club
iTrader: (2)
Joined: Jan 2011
Posts: 1,215
Likes: 1
From: Old Bridge, NJ/Corpus Christi, TX
Great job! Told ya you would get 700! I'm gonna run this boost setting on the street with this turbo on my forged 370 with ported lsa heads so now I'm real excited to see what mine makes when it's done...
