S10 377 Ram S480
#21
Teching In
Thread Starter
Update 2015
Installed M/T 30" tall drag radial tires and hitting 15# of boost now. It spools fast and blows the tire off until you lift. Fun is right but spinning is not winning and thats all it does right now. AMS boost controller is on the list. Adding some weight and adjusting the Cal-trac. Installed a 4" Magnaflow muffler and got rid of the fender exit. Hey Joe I made good use of your stickers HVH.
Last edited by LVTUNER; 01-18-2015 at 06:32 PM. Reason: added pic
#23
Teching In
Thread Starter
Boost Control
Thanks Ironblocked.
Went BIG on the boost controller and purchased the AMS2000 PRO. I started the install by drilling and tapping the wastegate for the 100 psi pressure sensor. Could tee it in. Then I found a mounting location for the solenoids. Thats were I am at now.
Went BIG on the boost controller and purchased the AMS2000 PRO. I started the install by drilling and tapping the wastegate for the 100 psi pressure sensor. Could tee it in. Then I found a mounting location for the solenoids. Thats were I am at now.
#25
bring this back. lol. how do you turn with the downpipe in there? I was thinking of keeping it tight by the control arm and go under the frame to run it back on the inside of the frame. is that possible?
#26
Teching In
Thread Starter
You are correct, turning was tight and decided to change the exhaust again. Sold the engine and just about finished building another 377 for it. Thinking about going to a fender exit on a cut-out and small 2 1/2" exhaust going out the back.
#28
Teching In
Thread Starter