V Bands
I am using stock manifolds, was thinking about the three bolt flange, but am leaning towards v bands due to ease and good looks. I am going to run a 2.25 O/D hot side with a t6 flange. I have been doing research on here on what mild steel v bands sizes to get, but haven't had much success? So as long as I get a 2.25 O/D v band assembly, what 2.25 O/D pipe do I need? I saw that the gauge is different on some steel? Where are you guys getting you V bands from and bellows too?
Here is one I did last week. Just chop the flange off put a nice bevel on the end.

Using these
http://www.ebay.com/itm/251658895365...%3AMEBIDX%3AIT
Trending Topics
The Best V8 Stories One Small Block at Time









