Progressive Vortech install with Pics and Q's
#102
12 Second Club
Thread Starter
iTrader: (13)
Join Date: Jul 2006
Location: Wisconsin
Posts: 1,142
Likes: 0
Received 0 Likes
on
0 Posts
Yes it's up and running. I just re-did the vacuum wiring today with the new catch can and check valve. I have to finish my boost gauge and fuel pressure gauge wiring and then tuesday morning it's off to Speed Inc.
#105
TECH Fanatic
iTrader: (41)
Join Date: Jul 2007
Location: Lancaster California
Posts: 1,431
Likes: 0
Received 0 Likes
on
0 Posts
After all that hard work it must feel great to see those results.
That's a nice flat torque curve, nice linear steady horsepower curve
and a nice safe and steady tune on the a/f ratio.
schaweet.
.
That's a nice flat torque curve, nice linear steady horsepower curve
and a nice safe and steady tune on the a/f ratio.
schaweet.
.
#113
12 Second Club
Thread Starter
iTrader: (13)
Join Date: Jul 2006
Location: Wisconsin
Posts: 1,142
Likes: 0
Received 0 Likes
on
0 Posts
They didn't say what the psi was on it's dyno. With the pulley it's somewhere between 7-8 psi. It was raining too much yesterday to really get on it but for the little that I did on the interstate I saw around 6 lbs, not taking it all the way up.
Honestly, it's about exactly what I was expecting and hoping for. I had a 125 shot on before this and knew I wanted to feel that range of power any time I put the pedal down.
Honestly, it's about exactly what I was expecting and hoping for. I had a 125 shot on before this and knew I wanted to feel that range of power any time I put the pedal down.