project tin can shootin for 9's
Sold off the intercooler, intake, ice tank, fuel system etc and making the switch to methanol. Got tired of the ice and dumping about 100 lbs more off the car by switching. By doing so will gain me more rear weight % for no prep so win/win all around.
Have a few buds running E85 and 30+lbs without an IC. (one is e98). Guys have been mixing 10-20% meth to the E85 to make a more capable fuel as well. (or just add meth inj) No doubt they would go quicker on meth, or intercooled but they are already faster than the 8.50 cages in the cars allow. I didn’t have the same luck with my hot air E85 motor. Knock on wood, with the new meth inj setup I haven’t munched any hard parts… yet. 5.50 sbe 5.3 deal.
Similar to A2W setups, methanol can be a huge pain. Maybe even more than the A2W if you plan to street drive it at all.
That said, another bud runs a 16 injector setup on 87 octane and meth. Cruises on stock injectors and the second set come on in boost only. A 5 gal meth cell lasts him a full night of racing and it’s the best of both worlds. But it’s not cheap or easy. Cable fuel pump, injectors, dual fuel system, and intake alone cost more than my chassis did!
for me, it’s just easier. I don’t have the time, or discipline, or patience to deal with the additional work required for using that fuel.
I know my 13.5:1 single turbo, hot air 370 would go faster on M1, but I just can’t deal with the crap that comes along with it.
Best of success to you!
The Best V8 Stories One Small Block at Time
Pretty capable fuel anyway. I’d try that WAY before I tried 100% meth. Maybe E98 with some meth at the turbo inlets.
I played with e98 a bit. Definitely not a night/day difference. I haven’t been able to get back to a track since. My seat of the pants meter says It may be a tiny bit quicker on gate (7lbs “street boost”). I had to add 16% more fuel, which seemed like a lot to me. I target 10.8:1 on gas scale.
I don’t know of any place in my area that has that class.
best of success to you.
Thread bump....
Quick winter update, welded in Tick torque boxes to add strength and more har angle. Made a 4 gal fuel cell and got rid of my 12 gal cell. Don't drive the car anymore so lost a lot of fluid weight off the car. Ditched the panhard bar, cut off all the brackets off the car and adding a wishbone from Hammer Concepts. Then made my own torque arm mount due to the old one pushing my rearend off center.













