My 9in. is installed!!
Thread Starter
9 Second Club
iTrader: (24)
Joined: Oct 2006
Posts: 2,796
Likes: 1
From: Kennesaw, Georgia
My 9in. is installed!! I just completed my 9in. swap yesterday. It is a moser 9in. housing with 31 spline axle's and a tractin lock with 3.50 gear's! The swap was real easy. The backing plate's from the 10 bolt swap over,no problem,the stock driveshaft work's,you just have to change out the u-joint for the correct yoke. I have a the spohn torque arm that mount's to the underside of the body and not the tranny, and that even bolted up with realitively no problem's. So far so good.
I just completed my 9in. swap yesterday. It is a moser 9in. housing with 31 spline axle's and a tractin lock with 3.50 gear's! The swap was real easy. The backing plate's from the 10 bolt swap over,no problem,the stock driveshaft work's,you just have to change out the u-joint for the correct yoke. I have a the spohn torque arm that mount's to the underside of the body and not the tranny, and that even bolted up with realitively no problem's. So far so good.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
I had another thread going where I asked if body modifications or alterations had to be done. They advised some slight tweeking of sheet metal to get the spohn torque arm (what I have) to fit with the 9 inch as it may hit the back seat support.
did you encounter this, or maybe, what did you have to do to get it to fit?
did you encounter this, or maybe, what did you have to do to get it to fit?
Thread Starter
9 Second Club
iTrader: (24)
Joined: Oct 2006
Posts: 2,796
Likes: 1
From: Kennesaw, Georgia
I had another thread going where I asked if body modifications or alterations had to be done. They advised some slight tweeking of sheet metal to get the spohn torque arm (what I have) to fit with the 9 inch as it may hit the back seat support.
did you encounter this, or maybe, what did you have to do to get it to fit?
did you encounter this, or maybe, what did you have to do to get it to fit?
