2010 SS at the track
Thread Starter
Teching In
Joined: Mar 2007
Posts: 29
Likes: 0
From: Gulfport MS
2010 SS at the track Last night went to the local test and tune and was setting in line. I look to my right and what do I see a red SS sitting in tech. After I made my run I went to the stands to watch him. He bogged the hell out of his launch and ran 13.8 @ 105. He get's back in line and go's again well he launches a hell of a lot better and ran a 13.5 @ 109 but he f up his rear end and had to be hauled off on a roll back. The damn car did not even have plates on it yet. I wonder if this is happening alot.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Makes me feel better about my 02SS. It did 13.2 - 108 stock with a 6 speed. And the 10 bolt went 12000 mi with twin turbos and 575rwhp.
(then blew up)
I'm sure people are going faster, and with better luck.
(then blew up)
I'm sure people are going faster, and with better luck.
Sorry this made me laugh, I have been thinking the same thing every time I see the "it's a pig" or "it's to expensive" comments.
On another story so the rear end broke, Can't even count how many 03 cobra's I saw getting flat bedded from the track when they first came out. Still a beast of a car.
Oh wait, my 02 Z's rear end broke at a red light on 245 Good Year GSC's.
I would imagine the guy launched wrong, had horrible wheel hop and snapped the half shafts. This can and will happen to any IRS car if you launch it wrong. Much easier to replace half shafts than a 10 bolt rear.
On another story so the rear end broke, Can't even count how many 03 cobra's I saw getting flat bedded from the track when they first came out. Still a beast of a car.
Oh wait, my 02 Z's rear end broke at a red light on 245 Good Year GSC's.
I would imagine the guy launched wrong, had horrible wheel hop and snapped the half shafts. This can and will happen to any IRS car if you launch it wrong. Much easier to replace half shafts than a 10 bolt rear.
LS1Tech Sponsor
Joined: Feb 2006
Posts: 1,170
Likes: 1
From: Rockfield Kentucky
I would love to know what he broke. The parts for the 2010 Camaro are very stout. The stubs into the carrier are 32 spline. The ring gear looks to be more than 8.6" in diameter.
The right side shaft is massive.
I would not use the launch mode, IMO the fact that it controls the throttle body or spark would encourage wheel hop.
I have run 12.99 with Nitto 305/30/20 Drag Radials. The torque management tries to kill power and that hurts the launch.
Others on here report that they improved the launch when the torque management was disabled.
No warranty on that though
Robin
The right side shaft is massive.
I would not use the launch mode, IMO the fact that it controls the throttle body or spark would encourage wheel hop.
I have run 12.99 with Nitto 305/30/20 Drag Radials. The torque management tries to kill power and that hurts the launch.
Others on here report that they improved the launch when the torque management was disabled.
No warranty on that though
Robin
11 Second Truck Club
Joined: Jun 2002
Posts: 536
Likes: 0
From: Alvin, TX
I can guarantee that when I ran my stock 04 Z06 and wife's 05 GTO M6 at the track if I had not lifted when the wheel hop began things would have broken. The driver needs to know when to take care of the car, maybe this guy tried to stay WOT through massive wheel hop.
Bingo!! Wheel hop will tear some **** up if you stay in it!
That sucks, I thought the different OD of the other shaft was going to help reduce hop? I guess its ever present on IRS cars?
And to everyone who loves to bash the 5th gen.... maybe you better take a closer look at your 4th gen...I love them, but there is plenty to bitch about there as well...
And to everyone who loves to bash the 5th gen.... maybe you better take a closer look at your 4th gen...I love them, but there is plenty to bitch about there as well...
TECH Enthusiast
Joined: Jun 2005
Posts: 525
Likes: 0
That sucks, I thought the different OD of the other shaft was going to help reduce hop? I guess its ever present on IRS cars?
And to everyone who loves to bash the 5th gen.... maybe you better take a closer look at your 4th gen...I love them, but there is plenty to bitch about there as well...
And to everyone who loves to bash the 5th gen.... maybe you better take a closer look at your 4th gen...I love them, but there is plenty to bitch about there as well...
http://www.youtube.com/watch?v=p2xB90FLGXk