QTP Longtubes won't slide in
#1
On The Tree
Thread Starter
iTrader: (4)
Join Date: Dec 2011
Location: Illinois
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
QTP Longtubes won't slide in
I have a 2001 trans am and just bought some QTP headers off of ebay. I believe they were off of a 98 camaro. I have my manifolds off spark plugs out coil packs and valve covers off. I know the headers must be installed from the bottom but I cannot manage to get them in. I can get the drivers side about half way up and have no idea how to get the passenger side in. Any ideas will be greatly appreciated. Thanks!!!
#4
TECH Enthusiast
iTrader: (8)
Join Date: Dec 2004
Location: MN
Posts: 525
Likes: 0
Received 0 Likes
on
0 Posts
Good luck your not the first one to have problems getting them in. The biggest help is if you have a aftermarket k member it makes them a piece of cake then. They will go in but you will have to force them in, I would try removing the drivers side motor mount that is normally the side that I have always had problems with. And then jack the motor up a little bit to get it away from the k member.
#5
On The Tree
Thread Starter
iTrader: (4)
Join Date: Dec 2011
Location: Illinois
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for all the responses I will try removing the motor mount. It just seems like the passenger side will be harder then the drivers. Im pretty sure the longtubes for the 98 camaros will fit a 01 trans am but could anyone confirm this.