Speed Engineering Race Version Headers Now Available!!
#1246
TECH Addict
iTrader: (36)
Anyone running the speed engineering off road Y with a tunnel mount MWC torque arm? Is the MWC double drop cross member the only one that will work with this Y pipe due to the location of the merge? I'd like to use the catback cross member for more ground clearance so if anyone has used it with this setup and can confirm good fitment, please comment.
#1251
TECH Addict
iTrader: (36)
Anyone running the speed engineering off road Y with a tunnel mount MWC torque arm? Is the MWC double drop cross member the only one that will work with this Y pipe due to the location of the merge? I'd like to use the catback cross member for more ground clearance so if anyone has used it with this setup and can confirm good fitment, please comment.
#1252
TECH Regular
iTrader: (12)
It's just two 3" pipes merged into a 4" pipe. There was an old thread on here about putting in a 4" I pipe to cut rasp with a y pipe. I figured I'd try it. Funny thing is it's raspy as **** compared to my 3" y pipe and cat back on my 4th gen. I might play with other set ups later, or try a resonator instead of a pipe. Maybe even build true duals when I decide to replace the muffler.
#1254
Yes, we have them on eBay as well. You pay a little more in shipping, but the parts are the same cost. Here's a link:
http://www.ebay.com/itm/361114865729
Thanks
Sean
http://www.ebay.com/itm/361114865729
Thanks
Sean
#1255
TECH Senior Member
iTrader: (25)
Yes, we have them on eBay as well. You pay a little more in shipping, but the parts are the same cost. Here's a link:
http://www.ebay.com/itm/361114865729
Thanks
Sean
http://www.ebay.com/itm/361114865729
Thanks
Sean