Im about to put a set of trick flow 215s,a cam (dur 230-236,lift 613-608,112 lsa)on my car. I already have kooks long tubes(1 3/4), kooks catted y, corsa catback, fast90,nw90 tb, mti lid, mass air end, racetronics fuel pump.I also have a stock bottom end motor, and a auto with a 3400 vig stall.I was wondering what you guys thought i would put down for numbers,also if you would put any n20 on it ? thanks in advance.

 

If I had to guess...440rwhp maybe. Spraying it is entirely up to you. I think I would be happy with that set up and no juice.

 

440rwhp sounds very close
Is that a ported fast 90? Porting make good numbers.
With the right chamber size and head gasket you should make more.
something like 60cc and a .030 or .040 head gasket.
i was told that cometics has a .030 gasket they don't list.

 

440s a fair est. With that setup I would encourage you to go with a bigger injector...especially if you do decide to spray.

 

what would you use on the injector size?

 

the reason im asking about the spray is my wife bought me a new nx kit for christmas and i didnt want it to go to waste, or have to sell it.

 

no its not ported yet i have been thinking about it though. i dont know what size the gaskets are i got them from mti when they were around.

 

39#

Like I said, it's your preference. If you set it up right, with all safety features, a 150 shot or less is ok. I wouldn't ask much more out of your shortblock.

If you have the money, do it, might as well get it done before it all comes together.

 

i wouldnt even spray that much maybe a 75 shot at the most

 

453 rwhp

 

Somewhere in the 440 range sounds about right.

 

that sounds respectable

 

once you spray it you wont be able to stop, too much fun, i ran a 150 shot on my bone, bone stock engine for 2 years with no issues. Just make sure you have the fuel and timing spot on.

 

thanks

 

When is it gonna be ready?

 

trying to have it done by next weekend i just have to get some gaskets and a water pump and im ready to go for it.