Took my valve covers off, need help!
#1
TECH Fanatic
Thread Starter
iTrader: (7)
Join Date: Dec 2007
Location: FL
Posts: 1,752
Likes: 0
Received 0 Likes
on
0 Posts
Took my valve covers off, need help!
I unbolted everything to the point where I can pull my valve covers and I've been using LS1howto to get there.
I cannot get my valve cover out of my bay because I have a line the looks to be covered in duct tape and said "CAUTION FLAMMABLE!" on it. Can I remove this and if so, how?
I cannot get my valve cover out of my bay because I have a line the looks to be covered in duct tape and said "CAUTION FLAMMABLE!" on it. Can I remove this and if so, how?
Trending Topics
#8
TECH Fanatic
Thread Starter
iTrader: (7)
Join Date: Dec 2007
Location: FL
Posts: 1,752
Likes: 0
Received 0 Likes
on
0 Posts
Ok, I need help getting it off, I can't figure it out. Theres no place for a wrench, and the other line (that goes into the electrical thing next to the green **** in the second pic) won't come out.
#11
Teching In
Join Date: Dec 2008
Location: Cleveland TN
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
as stated above you are going to need a release tool to do that, you can either use a a/c line tool 3/8" or a Gm gas line tool
#15
TECH Fanatic
Thread Starter
iTrader: (7)
Join Date: Dec 2007
Location: FL
Posts: 1,752
Likes: 0
Received 0 Likes
on
0 Posts
Checking for a bent pushrod.
I'm done, I didn't find anything.
My car makes a diesel sound and its coming from the driver side, one of the first 2 cylinders. I've been told it might be a lifter, now I'm thinking that too.
I'll have a new sound clip later.
I'm done, I didn't find anything.
My car makes a diesel sound and its coming from the driver side, one of the first 2 cylinders. I've been told it might be a lifter, now I'm thinking that too.
I'll have a new sound clip later.