IRL (RAIN!!!) Chain from SDPC available for a limited time
Price for the chain is $274.95
OR the price for the timing sets
LS1/6 style $339.95
LS2 style 24X 339.95
LS2 style 58X 339.95 (3 bolt only no single bolt)
plus shipping.
Again there are only 30 avail, either in chain form only, or the entire set.
These prices are NOT on the website....phone order only, call/pm me(John x355) or Jesse (x358)!!!
we can also match this chain up to a GM stock gear set for the single bolt crowd! PM or call pricing on that!
But the sets are the hex-adjust so they are a good timing gear set as well.
IF i had an LS engine, i would have already grabbed one up. These are supposed to be the last remaining supply of these chains.....period.
Then it will be these same threads again about where you can get them from and how you WISH they were still made. Well, dont wait until then, get them NOW. The price cannot be beat, i mean really instead of inflating them because they are the few left, we are discounting them so that the people that dont want to spend $400+++ can get them in an entire timing set.
These are hex adjust sets as well, meaning you dont have to take the pump/bottom gear off to adjust the cam advance/retard. If you have a 2 piece timing set, you dont even have to take the balancer off......a MAJOR plus.
We can make a package deal with the QTP or Edelbrock 2 piece front covers to make this the best deal out there!!!
Last edited by Beau@SDPC; Jun 15, 2009 at 01:40 PM.
Trending Topics
The Best V8 Stories One Small Block at Time
also, the package deals really do not end, either a 2 piece cover, the gm cover with seal, bolts, gasket, sensor, harness, and maybe the cam/knock sensor extension harness and gm crank bolt or arp crank bolt.....ask for details or pm/call for pricing!!!!
IRL chain on the left...sorry lol


and some statistics on the IRL chain as well....
outside link is .050 thick
inside link is .070 thick
the width of the roller link that rides on the chain is .208
the width of the pin is .542 total
if there is anything else that yall want measured, then just let me know
hope the pictures are good enough for ya
Last edited by Beau@SDPC; Jun 16, 2009 at 10:52 AM.




