RoadKill cams (RoadKill 6.0) Need Cam Card Bad !!!
#1
Teching In
Thread Starter
Join Date: May 2013
Location: Pilot Point ,Tx
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
RoadKill cams (RoadKill 6.0) Need Cam Card Bad !!!
Here's the deal guy ... I bought my 04 GTO with all the mods done ... I'm from Texas and there's a guy down in West Texas building these RoadKill cams ... I'm just throwing this out there hoping that someone has the RoadKill 6.0 and can send me the cam card / Specs ??? I've tried contacting Edgar down in West Texas but nothin came of that !!! So I'd really appreciate it if one of you guys with this cam or know someone with this cam can help me out .... Thanks
#6
Teching In
Thread Starter
Join Date: May 2013
Location: Pilot Point ,Tx
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys .... I was told 240/246 but was really wanting all the numbers on this cam ... I went ahead and went with the 3800 stall ... I'm guessing the rpm power range is in the 3000-7000 rpm range cause man this thing pulls hard ... Thanks again
Trending Topics
#8
Super Hulk Smash
iTrader: (7)
It's a big cam. I don't know much beyond the specs I posted. I would assume XE-R lobes; but I don't know the ICL. If you throw a degree wheel on there you could find out pretty easily where it's installed.
If it runs pretty good, then there you go.
A 4000 or 4400 stall probably would match up better given the powerband, but 3800 should work.
If it runs pretty good, then there you go.
A 4000 or 4400 stall probably would match up better given the powerband, but 3800 should work.
#12
Teching In
Thread Starter
Join Date: May 2013
Location: Pilot Point ,Tx
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
#19
TECH Senior Member