What is causing this GTO to run slower?
#41
I don't know anything about the tech 2 but can you monitor everything with it?( I would sure hope so) I am sure the tech 2 can reset your tune since some people have went to the dealer with a tune and the dealer upgraded the pcm and they lost there tune.
I have hptuners and you can just about monitor everything to find the problem.
I have hptuners and you can just about monitor everything to find the problem.
#42
You really need to find someone who has a scan tool and can use it to figure this out. There's a ton of possibilities that can the loss of power. Grab a scan tool.
Look at
Fuel Trims short and long-shouldn't be any more than +/- 10
MAP vacuum reading
MAF grams reading at idle
Knock sensors pulling timing?
ECT and IAT temps
A/F sensor
Or take it to a shop have a good diagnostic tech look it over for an hour and have them report back with what they find and tackle the job of fixing it yourself. I'll cost you anywhere from 80-120.
Look at
Fuel Trims short and long-shouldn't be any more than +/- 10
MAP vacuum reading
MAF grams reading at idle
Knock sensors pulling timing?
ECT and IAT temps
A/F sensor
Or take it to a shop have a good diagnostic tech look it over for an hour and have them report back with what they find and tackle the job of fixing it yourself. I'll cost you anywhere from 80-120.
#43
You really need to find someone who has a scan tool and can use it to figure this out. There's a ton of possibilities that can the loss of power. Grab a scan tool.
Look at
Fuel Trims short and long-shouldn't be any more than +/- 10
MAP vacuum reading
MAF grams reading at idle
Knock sensors pulling timing?
ECT and IAT temps
A/F sensor
Or take it to a shop have a good diagnostic tech look it over for an hour and have them report back with what they find and tackle the job of fixing it yourself. I'll cost you anywhere from 80-120.
Look at
Fuel Trims short and long-shouldn't be any more than +/- 10
MAP vacuum reading
MAF grams reading at idle
Knock sensors pulling timing?
ECT and IAT temps
A/F sensor
Or take it to a shop have a good diagnostic tech look it over for an hour and have them report back with what they find and tackle the job of fixing it yourself. I'll cost you anywhere from 80-120.
What if there are no faults that show up on the scan tool. Am i looking for CEL or going thru everything even thou there is no code?
#44
Look at the values. Introduce vacuum leaks(lean it out) and carb spray(fatten it up) and make sure fuel trims are adjusting correctly.
#45
Alright folks! Bringing this back up with an update.
Yesterday we took the injectors out just to clean them and, lo and behold, one injector wasn't flowing like its siblings! Replaced it and now a whole second has been shaved off the 0-60 time.
Good catch gagliano!
As happy as i am to find the culprit, fact is, car is still slow. 7.4 secs to 62mph is embarrassing for an LS1.
Yesterday we took the injectors out just to clean them and, lo and behold, one injector wasn't flowing like its siblings! Replaced it and now a whole second has been shaved off the 0-60 time.
As happy as i am to find the culprit, fact is, car is still slow. 7.4 secs to 62mph is embarrassing for an LS1.
#46
TECH Apprentice
iTrader: (10)
Join Date: Mar 2010
Location: El Paso, TX
Posts: 319
Likes: 0
Received 0 Likes
on
0 Posts
If the car is hesitating when you goose it then you might want to give the O2 sensors a clean or replaced. A faulty O2 will make a car miss fire and bog down like crazy until WOT. Also I wasn't sure if this was answered but is the SES light on at all maybe you should start from there and just get a simple code reading.
#47
TECH Enthusiast
I have a couple of "off the wall" theories . . .
(1) The Traction Control is not disengaging, even though the switch is in the "off" position.
(2) The Torque Converter is stuck in "lock-up mode".
(3) Did you change the Air Filter ?
Just some thoughts . . .
(1) The Traction Control is not disengaging, even though the switch is in the "off" position.
(2) The Torque Converter is stuck in "lock-up mode".
(3) Did you change the Air Filter ?
Just some thoughts . . .
#50
TECH Senior Member
Alright folks! Bringing this back up with an update.
Yesterday we took the injectors out just to clean them and, lo and behold, one injector wasn't flowing like its siblings! Replaced it and now a whole second has been shaved off the 0-60 time.
Good catch gagliano!
http://www.youtube.com/watch?v=wk6AgS-ShhU
http://www.youtube.com/watch?v=y5L5yF82-yI
As happy as i am to find the culprit, fact is, car is still slow. 7.4 secs to 62mph is embarrassing for an LS1.
Yesterday we took the injectors out just to clean them and, lo and behold, one injector wasn't flowing like its siblings! Replaced it and now a whole second has been shaved off the 0-60 time.
Good catch gagliano!
http://www.youtube.com/watch?v=wk6AgS-ShhU
http://www.youtube.com/watch?v=y5L5yF82-yI
As happy as i am to find the culprit, fact is, car is still slow. 7.4 secs to 62mph is embarrassing for an LS1.
For example:
#51
TECH Apprentice
iTrader: (10)
Join Date: Mar 2010
Location: El Paso, TX
Posts: 319
Likes: 0
Received 0 Likes
on
0 Posts
Is this a chevy lumina SS? i just noticed the overlay on the speedo. if so it would also help if you state if its a 4 door, ute or coupe being as they have a weight difference. but i'm going to guess that they both are coupes by how to referred to them as gtos. or is it a goat with a lumina ss overlay?