found in first oil change after rebuild...
#1
On The Tree
Thread Starter
Join Date: Oct 2010
Location: Tupelo, MS
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
found in first oil change after rebuild...
put about 250 miles on engine before i changed the oil. i'm using a magnetic oil plug, and was expecting to see a few shavings. but i found this. any ideas?
i used the dime to give an idea of the size.
i used the dime to give an idea of the size.
#3
On The Tree
Thread Starter
Join Date: Oct 2010
Location: Tupelo, MS
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
I actually had an upgrade done. Or at least I think I did. Lsr cam and springs, I'm sure of, but not sure about the roller rockers. Shouldn't that all come in the kit? Which if it did, that may be a piece from the old setup that was dropped by mistake.
#5
I agree. Looks like a OEM rocker needle brg. Check the rockers.
#7
Registered User
Join Date: Apr 2013
Location: West chester ohio
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
#8
On The Tree
Thread Starter
Join Date: Oct 2010
Location: Tupelo, MS
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
#9
TECH Senior Member
iTrader: (9)
The needle bearings are inside the rocker at the pivot point. The trunion upgrade creates a cage around the bearings to stop them from falling out. You will want to look thoroughly EVERYWHERE and see if it was just one rocker or multiple ones that spilled.
If the bearings start going through your oiling system you can end up with a toasted motor.
#19
On The Tree
Thread Starter
Join Date: Oct 2010
Location: Tupelo, MS
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
I'll take one this afternoon when I get home. My mechanic said that one or more of the lifters were damaged and very well could be a lifter bearing or pin.