Pushrods diameter
Pushrods diameter Hey all,
I'm rebuilding my ls3 engine and was wondering what diameter pushrods I need to get. I'm using the morel 5290 lifters with tick street heat stage 2 cam. On my heads I have pac double springs with .650 and retainers. I'm also using the upgraded trunion kit by bt. Just not sure abt the diameter of the pushrods.
I'm rebuilding my ls3 engine and was wondering what diameter pushrods I need to get. I'm using the morel 5290 lifters with tick street heat stage 2 cam. On my heads I have pac double springs with .650 and retainers. I'm also using the upgraded trunion kit by bt. Just not sure abt the diameter of the pushrods.
These are our Tick Performance dual taper 3/8" 5/16" .135" wall push rods that we sell for 250.00 shipped.
If you want the strongest stiffest push rod you can fit in your push rod passage with a stock casting and most LS aftermarket castings, this is it.
If you want the strongest stiffest push rod you can fit in your push rod passage with a stock casting and most LS aftermarket castings, this is it.
Trending Topics
I got these exact ones. Went from the comp magnum 3/8" pushrods to these and the trends for twice as good.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
What Tim said.. I actually have 3/8 mantons in my engine but 11/32 are good too. 
Can these be made up in non (LS) standard sizes? I'll be running a Cammotion LLSR with T&D shaft rockers. Have no idea what the final length will be, but not likely to be 7.40"...
We're planning on stocking these in the near future, but only in the more commonly used lengths such as 7.400, 7.425, 7.45, 7.475, 7.500 etc.
The LS3 Stage 2 Street Heat is not a cam I would recommend for a 418" N/A engine, nor would I recommend it for a 418" boosted engine. That cam was designed to work with N/A LS3 engines, or 3.622" stroke LS3 headed engines.
Not yet, but we're working on it!
The pushrods are made from 4130 chromoly The Rockwell hardness is RC 58-62 and tensile strength 689 MPa min.