952HP 441 w/Frankenstein F710S
#1
952HP 441 w/Frankenstein F710S
I'm so excited I bought my set!
Frankenstein F710 LS7 Headed made 952HP 758TQ
MAST 305 LS7 Headed made 904HP 718TQ
Gregg Good CID LS7 headed made 886HP 719TQ
All these were revved to 7200rpms
ALL MOTOR!!!
Baldwin Racing Enigine Built 3 LS 441s same compression different intakes some similar parts not just the heads.
Read and make your own conclusions as this info was given to me during a 2min conversation. Need full details contact Baldwin and FEDFrankenstein F710 LS7 Headed made 952HP 758TQ
MAST 305 LS7 Headed made 904HP 718TQ
Gregg Good CID LS7 headed made 886HP 719TQ
All these were revved to 7200rpms
ALL MOTOR!!!
Last edited by 62nalide; 07-09-2019 at 09:48 AM. Reason: Misinformation given
#2
TECH Senior Member
Turning those distributors is costing HP. Coil on plug would be better, unless rules prevent that from happening.
#4
TECH Senior Member
#5
TECH Enthusiast
Impressive delta between the other heads. Should be interesting to get some details. Was this they were equal until 6,000 rpm etc.
#7
Nice. That some crazy power for only 7200rpms. You would think they needed high 7000's at the least to reach those numbers.
Trending Topics
#16
valve length says alot with a 10degree valve angle
Black Nitride Coated Stainless Steel Intake Valves 2.250 / 5.675" (Hydraulic)
Black Nitride Coated Stainless Steel Intake Valves 2.250 / 5.875" (Solid Roller)
Black Nitride Coated Stainless Steel Intake Valves 2.250 / 5.675" (Hydraulic)
Black Nitride Coated Stainless Steel Intake Valves 2.250 / 5.875" (Solid Roller)