damn stock rockers. Is there an adjustable l92 rocker out yet?
#1
damn stock rockers. Is there an adjustable l92 rocker out yet?
I noticed some more damn valvetrain noise, so i took off the valve covers and found an exhaust rocker had come appart spilling the needle bearings. (found 28 of the needle bearings)The stock rocker arms blow. Where can I get a set of adjustable l92 roller rocker arms without paying over 1 grand on jessels?
Last edited by CamaroRick; 12-10-2009 at 01:46 PM.
#7
Send your stockers to Harland Sharp for rebuild.
They will replace the bearning assembly with a much better design which will not fall apart.
They clean them up ( look brand new ) and include new mounting hardware
It will cost you much less than aftermarket rockers.
We have sent several sets to them and have been more than satisfied with the results.
Ryan
They will replace the bearning assembly with a much better design which will not fall apart.
They clean them up ( look brand new ) and include new mounting hardware
It will cost you much less than aftermarket rockers.
We have sent several sets to them and have been more than satisfied with the results.
Ryan
Trending Topics
#8
FormerVendor
iTrader: (53)
Send your stockers to Harland Sharp for rebuild.
They will replace the bearning assembly with a much better design which will not fall apart.
They clean them up ( look brand new ) and include new mounting hardware
It will cost you much less than aftermarket rockers.
We have sent several sets to them and have been more than satisfied with the results.
Ryan
They will replace the bearning assembly with a much better design which will not fall apart.
They clean them up ( look brand new ) and include new mounting hardware
It will cost you much less than aftermarket rockers.
We have sent several sets to them and have been more than satisfied with the results.
Ryan
#10
LS1Tech Premium Sponsor
iTrader: (4)
I believe we have the YT in stock! I haven't seen them fail, but I've talked to guys that have seen it fail.
__________________
Jason
Co-Owner, Texas Speed & Performance, Ltd.
2005 Twin Turbo C6
404cid Stroker, 67mm Twins
994rwhp/902lb ft @ 22 psi (mustang dyno) www.Texas-Speed.com
Jason
Co-Owner, Texas Speed & Performance, Ltd.
2005 Twin Turbo C6
404cid Stroker, 67mm Twins
994rwhp/902lb ft @ 22 psi (mustang dyno) www.Texas-Speed.com