Borla Xr1s w/ Turndowns and Flanges. Ready To Mount.
08-13-2006 | 01:05 PM
#1
Borla Xr1s w/ Turndowns and Flanges. Ready To Mount. These were mounted on Pacesetter LTs.
70 Miles MAX on them. I put them on then a week later started my rebuild.
These mufflers sounded awsome at idle, driving and WOT.
The setup was on and LT1 but can easily be changed to LS1.
Mufflers are Stainless Steel 3in/3out. Flanges are 3in. Turndowns are 3in. They also have very nice hangers.
It is pretty much a plug and play system to install. Flange them up and then mount a bolt for the hanger and your good to go.
Here are some pics.
I paid out the *** for all this ****.
*234 for the mufflers
*30 for the flanges
*25 for the turndows
*229 for fabrication
Looking to get $265 SHIPPED out of it all.
PM ME, with offers and questions.
Tony.
70 Miles MAX on them. I put them on then a week later started my rebuild.
These mufflers sounded awsome at idle, driving and WOT.
The setup was on and LT1 but can easily be changed to LS1.
Mufflers are Stainless Steel 3in/3out. Flanges are 3in. Turndowns are 3in. They also have very nice hangers.
It is pretty much a plug and play system to install. Flange them up and then mount a bolt for the hanger and your good to go.
Here are some pics.
I paid out the *** for all this ****.
*234 for the mufflers
*30 for the flanges
*25 for the turndows
*229 for fabrication
Looking to get $265 SHIPPED out of it all.
PM ME, with offers and questions.
Tony.
Last edited by Speed Density; 08-29-2006 at 11:14 PM.
