For sale is my complete 402 that made 550hp/495rwtq through a T56/9inch w/4.57s, and 28/11.50 slicks. Engine has about 20 passes and less than 100 street miles. I am including the following, completely assembeled:

LS2 block, (brand new casting w/ all covers and sensors)
Eagle 4340 crank and h-beam rods, JE pistons, totalseal rings
TFS LS2 heads, 64cc comb chamber
Comp pushrods
Harland rockers
Valvecover spacers
JP Billet LS2 double timing set
Custom Comp 236deg cam
Ported FAST 90 (your choice of LS2 or Holley TB)
42lb/hr injectors
ASP balancer
ported LS6 oilpump
Will include a dynotuned file for the engine

Also for sale is any other supporting mods, or install just pm, or call me if you have any questions. Looking for 9300.00. If you have any questions, give me a call at 513 831 6000

Thanks-Dave Smith

 

to the top

 

To the top for a crazy fast motor!

 

Why are you selling with such low miles?

 

Rich would you agree that you were outperformed by the bike... LOL thats funny **** .....is it fast haha

 

To the top for one bad azz motor that is still available and will take your f-body into consistent low 10s on MOTOR! For the time being I have decided that after just buying a HARLEY I need to just keep my f/i set-up for now.

So this bad boy is still available for someone looking for the baddest *** LS2 402 motor available to drop into your engine bay right now!

 

if this motor is still available the 1st of May, i most likely will be buying it.

 

Engine STILL for sale!



I change my set up on the shop car every 1-2 years. This one was set up to develope a cam/heads package for a ***** out street/strip 400 cube LSx engine, and I have yet to see any other engine dyno/perform like this one did with a small hyd. cam. (havent even seen many put up 550+rwhp with cams in the 250s). Its time to move onto another set combo!

 

Lots of tire kickers, no buyers. Price is negotiable on this 9 sec cable street/strip engine!

 

so does this motor have everything need to just drop into a car? or will i have to trade some parts off of the existing motor..?? im thinking of putting it into a rc/sb chevy

 

please do not post links to your shop, this is not permitted here. I'll allow this thread to remain since it is a used item, but please do not post contact info for your shop again.

 

Sorry, I'll host the dynograph elsewhere

 

Everything but the engine management, and oilpan is for sale. However, I could sell you that as well (Your choice of DFI or factory). Give me a call or pm with any questions.
Thanks-Dave