LS1 Lid + LS1 rad support + stock hood = DONE
#1
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
EDIT: writeup here http://joelrdevriendt.com/?p=46
sheet metal wasnt my thing, i think this looks nicer
excuse the filthy engine bay
![](https://photos-a.ak.fbcdn.net/hphotos-ak-snc3/hs166.snc3/19345_719382150465_22401114_42450434_2295166_n.jpg)
![](https://photos-e.ak.fbcdn.net/hphotos-ak-snc3/hs166.snc3/19345_719382160445_22401114_42450436_7924703_n.jpg)
sheet metal wasnt my thing, i think this looks nicer
![Nod](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_nod.gif)
![](https://photos-a.ak.fbcdn.net/hphotos-ak-snc3/hs166.snc3/19345_719382150465_22401114_42450434_2295166_n.jpg)
![](https://photos-e.ak.fbcdn.net/hphotos-ak-snc3/hs166.snc3/19345_719382160445_22401114_42450436_7924703_n.jpg)
![](https://hphotos-snc3.fbcdn.net/hs166.snc3/19345_719382155455_22401114_42450435_3588494_n.jpg)
Last edited by JoeliusZ28; 08-31-2010 at 03:14 PM.
#4
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
i did the lid install the same way everyone else has done it, then just modified the LS1 radiator support to fit it. I had to trim a LOT of plastic off it. There is probably only 50% of it left lol. My idea was to just set the lid down inside the shroud instead of on top of it and this is what i got. the support is set back a few inches from where it would normally be, i used self tapping screws to secure it. Its VERY solid, i couldnt be happier with it.
I have more pictures i can post if people want, but im headed out the door right now.
I have more pictures i can post if people want, but im headed out the door right now.