Wicked94Z

iTrader: (26)

I dinged up 3 of my old pro-mag rockers from valve spring bits, hardened locks, etc flying around under the valve cover. I ordered a set of 8 of these to use on the intake side, and 8 of the existing pro-mags on the exhaust side. I'm not usually a fan of aluminum pieces but I got them with a coupon for 125 bucks shipped which isn't bad. I'm curious to swap them from intake to exhaust on the dyno, I'm thinking a stiff valvetrain like mine could benefit from a few grams reciprocating mass lost on the intake side.

http://www.compcams.com/WhatsNew/Fil...rockerarms.pdf

GreenBlood55

iTrader: (1)

is the coupon sharable?

Puck

iTrader: (17)

Interested in your results, keep us posted.

sweetbmxrider

iTrader: (13)

I agree.

SS RRR

iTrader: (2)

Wondering with that contour design if it will allow for larger spring diameters.

Wicked94Z

iTrader: (26)

I think 1.650" or so?

SS RRR

iTrader: (2)

I'm sure you'll check the sweep. I'm curious to see if it changes at all...

BIGCAT7274

we run the regular comp gold. we put them in this summer. so far nothing to complain about.

SoxXpupPeT

iTrader: (34)

I too run the regular comp golds and i love them. Those look really sharp! GL with the install. interested in results