cucui

iTrader: (2)

In the process of doing the 24x conversion and need some ideas of how to set up my coils

SAPPER

iTrader: (10)

Give me a week or so & I'll show you the best way to do it. You will need aluminum valve covers though. Maybe I'll mock up a pic for you tonite. No one really responded to my thread regarding this so I did some thinking and came up with a great idea.

blk3rdgen91

am_muscl

iTrader: (19)

I'd like to see some of these as well!!

cucui

iTrader: (2)

Sapper go look out your back door, look to your left about 2 houses down I’ll be waving 2 you out my back door. Jacob

SAPPER

iTrader: (10)

4.5-14 scope on the FNAR 308...You can run but you'll only die tired.

So...... I come up with the greatest idea yet and you want to ask how to do it better???
Now you owe me!!!! LOL..... DICKK

Never could figure out your s/n. Wife doesn't teach me Espanol.

97Z28SS

iTrader: (5)

Here's mine before my install in the car, enjoy.
[IMG][/IMG]
[IMG][/IMG]

Blackbirdws6

iTrader: (7)

Shownomercy

iTrader: (1)

Stupid coil packs.

CALL911

iTrader: (17)

My pile

FSTFBDY

iTrader: (1)

Don't mind while I drooool over your "pile" Looks great !

CALL911

iTrader: (17)

Thanks. Hopefully it looks at least that good when I put it all back together.

daddyoisback

iTrader: (6)

here is mine, home made bracket welded to stock covers.

SAPPER

iTrader: (10)

That is the idea I'm going with except on the aluminum valve covers. I'm having spacers I made and tapped Tig'd on. Should look pretty good when done and very easy to work with. No brackets, etc. Will cost me about $60 total. because I'm paying to have then welded on.

daddyoisback

iTrader: (6)

I plan on doing the same when I get new valvecovers..I tigged these myself(as you can tell) but I will pay to have the aluminum welded up.

SAPPER

iTrader: (10)

I wasn't able to find any 6mm threaded spacers anywhere. And I searched for hours. Finally I found a company that sells 1" spacers then just tapped them out myself.

SAPPER

iTrader: (10)

Finally got done with the valve covers. Now just ne to touch up with powdercoating. I went with 1" spacers because my first set coils were round and turned out they were broke when I pulled the plug wires off. It seems some idiot before me tried removing the wires with pliers. But...They were free so no big loss. As for using the squares, I would have easily gotten by with 3/4". There's a good 1/2" of clearance.

tt383lt1

iTrader: (3)

here mine. truck coils

BizZzatch350

iTrader: (33)

LT4 Valve Covers with 24X brackets. Be cool if they were hidden under the cowl

BP Automotive

iTrader: (3)

Here are my brackets. Although the OP chose not to go with them, maybe they will help you figure out what you want in some way. I have redesigned them a tad and cleaned up the design too.