stroker times?

Reply Subscribe

Thread Tools

Search this Thread

Feb 16, 2006 | 12:57 PM

98vortecbw

Thread Starter

Launching!

Joined: Nov 2005

Posts: 282

Likes: 0

From: Baytown (dirty bay) , TX

stroker times?

what would a 383 stroker lt1 run with no mods AT ALL. not even exhaust? its a m6

Feb 16, 2006 | 01:02 PM

SAPPER

TECH Fanatic

iTrader: (10)

Joined: May 2004

Posts: 1,593

Likes: 267

From: Halfway back on the Highway to Hell...again!

Damn Guy, tryin to get that post count up??? LMAO

There are too many variables. A stroked motor (383) with a bigger cam may idle perfect, the same cam in a 350 will thump. If it is stroked, it could be a 383, 392, 396, 409?????????? there are endless possibilities.

Feb 16, 2006 | 02:03 PM

Badazgt

Teching In

Joined: Feb 2006

Posts: 3

Likes: 0

it would prolly not run that much lower times w/ a stock H/C/I. The point of a stroked motor is to increase air and without the supporting mods it'd flow almost like stock

Feb 16, 2006 | 03:04 PM

blkchevyz

TECH Fanatic

Joined: Oct 2003

Posts: 1,101

Likes: 0

you would get more power putting a set of headers on then you would with a stroker put together with stock parts.

Feb 17, 2006 | 07:58 AM

lt1taracing

9 Second Club

Joined: Jan 2006

Posts: 301

Likes: 0

From: ringgold,ga

when i blew my stock mtr. a couple years ago i built a 383 but everything else was stock 93 a4,3.23 gear. it had ran 8.9s in the 8th before and it went 8.2s after.

Feb 17, 2006 | 06:11 PM

lt1taracing

9 Second Club

Joined: Jan 2006

Posts: 301

Likes: 0

From: ringgold,ga

it also raised the comp. ratio about a point running flat tops. thats another four percent power gain. the big gain is torque. you can always add the bolt ons later. headers and exhaust picked it up another .3-.35 tenths in the 8th.