KILLERZ/28

well yesterday i was driving to the store to get gas car was running the best it has run in a while pulled in cut the car off put gas in it and went to start it back up and it had a dead skip like a plug wire was off check the plug wires they were all on so i drove it home changed the coil change the ignition module and all fuel injectors are pluged in still no luck. drove it today and it's like it is hitting the rev limiter but is doing it at 5000 grand i have the rev limiter set to 7500. I thinking it could be the FAMOUS opti hopefully not!!

Shawnzr2

Check your fuel pressure just in case. Have any plug wires laying against the headers?

LT1

iTrader: (1)

High chance it could be opti, are you getting coolant on the opti? check your water pump and coolant hoses. Usally acts up if you get moisture in it.

black95formula

how about bad gas?? maybe they just got a shipment and stired up some water?? try putting in some of that dry gas stuff....
but its probally the good old opti!!
just an idea.

KILLERZ/28

FOUND IT THANK GOD!! It was a plug wire laying on the header couldn't see it untill i jacked the car up and look at all the plug wires just to make sure and i spoted it.

thanks for all the input

TransAmdriv3r

iTrader: (10)

Man did you luck out, you must be grinning from ear to ear.
Really its not all that bad if ya had to do it.

infinitebird

iTrader: (11)

another reason to get otvc wires.

Dragframe

iTrader: (14)

I like the way they are ran stock. There is no other way to do it really with my turbo setup. And all my wires are far from getting melted

KILLERZ/28

ya i was very happy untill my transmission went out yesterday i can't catch a break all i want to do is drive it not work on it all the damn time. i think i have the late model Christina.

Formula96

you had me scared with the whole ran good as ever thing, a lot of times, right before a motor ***** out, it runs a lot better (loose is fast)

Red1996SS1519

iTrader: (7)

AAAAAANNNNNNNDDDDDD another reason to wrap the headers.

BOLO

iTrader: (40)

+2....plus it looks cleaner.

fireredz28

iTrader: (10)

I ran my wires in the stock location and never had any problems with my headers/wires. I had hooker shorties though if that makes a difference.

sweet-94z28

iTrader: (30)

Delteq wanted the wires through the stock looms but I got creative and went over the engine with stock headers. I think it looks BA