Max compression on a street car?
#42
Should be significant if you can do it without inducing timing retard.
Worth a good 20rwhp up top even with a mild cam.
Hell, just switching to thinner head gaskets is worth 5.
FWIW, I'm up around 12.1:1 with my new setup (zero-decked -4cc pistons) on pump gas.
I had 11.3 with the previous setup (stock deck and pistons) on pump gas.
Both setups use a cam with a very aggressive LSA.
#43
9 Second Club
iTrader: (4)
Join Date: Dec 2004
Location: Cali
Posts: 2,607
Likes: 0
Received 0 Likes
on
0 Posts
Just my .02 on this.... I think 12:1 is when you need to start looking into running premium fuel if you plan on beating on it....
If you're just running back and forth to the store then yeah run pump gas..... if you are going to the track run 108 or 110 or other premium race fuel. It's cheap insurance.. (Errrr rather expensive insurance at 10.00 a gallon)... but still worth it...
If you're just running back and forth to the store then yeah run pump gas..... if you are going to the track run 108 or 110 or other premium race fuel. It's cheap insurance.. (Errrr rather expensive insurance at 10.00 a gallon)... but still worth it...
#44
TECH Regular
iTrader: (9)
Just my .02 on this.... I think 12:1 is when you need to start looking into running premium fuel if you plan on beating on it....
If you're just running back and forth to the store then yeah run pump gas..... if you are going to the track run 108 or 110 or other premium race fuel. It's cheap insurance.. (Errrr rather expensive insurance at 10.00 a gallon)... but still worth it...
If you're just running back and forth to the store then yeah run pump gas..... if you are going to the track run 108 or 110 or other premium race fuel. It's cheap insurance.. (Errrr rather expensive insurance at 10.00 a gallon)... but still worth it...
#45
I would not tune a DD for race fuel though,
I'd either run a separate tune at the track or not run race fuel at all.
I do however tune for premium pump gas (92 Octane in this part of the country)
#47
12 Second Club
Thread Starter
iTrader: (7)
Join Date: Oct 2005
Location: NYC
Posts: 1,666
Likes: 0
Received 0 Likes
on
0 Posts
I started this thread like 6 months ago and now 4 1/2 months later after sending my motor to get done I got it back and the car is running. Its a 385 LT1 approx. 11.4:1 SCR and 8.79:1 DCR. I haven't hooked the laptop to it yet since i haven't been able to drive it normally. I'm all out of alignment. I put a tubular k member and lower adj a arms and I need to get those setup properly. Hopefully this Monday I'll take it to get done. Once its aligned I'll take it out for a thorough drive and hook up the laptop to it to see if it's knocking. Otherwise it feels fine and I don't hear any knock but that doesn't mean there isn't any. I'll keep you guys updated.