well i just ordered my monster :)
#1
On The Tree
Thread Starter
Join Date: Sep 2008
Location: Roanoke Rapids, NC
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Stage 3. i hope i made the right decision! from what i have read i think i did. i've put clutches in before but is ther anything special i need to know about this one?
#2
FormerVendor
iTrader: (38)
Join Date: Nov 2008
Location: Pearland, TX
Posts: 2,309
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Did you get their "supreme" package (I think that is what it is called) it comes with a new slave? If not, INSTALL A NEW SLAVE! You might want to check into Tick and their speed bleeder as well with everything already apart.
#4
TECH Senior Member
iTrader: (39)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
It's more of a remote bleeder. It replaces the bleeder screw on the slave cylinder. It's about 2-3 feet long so you can bleed the clutch easier instead of trying to reach inside the bellhousing.
Let us know what you think of the clutch when you get it installed. This is the one I am going with.
Let us know what you think of the clutch when you get it installed. This is the one I am going with.
#6
On The Tree
Thread Starter
Join Date: Sep 2008
Location: Roanoke Rapids, NC
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
i sure will.. it hasn't shown up on my door step yet but when it does i'll get it in the first saturday after that hopefully!! and let everyone know what i think about it