Hey my clutch is gone in my 98 Trans Am, I want to have a street and sometimes even a strip clutch to have a little bit of fun and still be reliable with. I dont plan on building the car anytime soon so I think a LS7 clutch would be the best bet. What flywheel to go with? I need to buy everything at one, clutch,flywheel,throw out bearin,alignment tool, etc. So where would be the best place to get this at? and cheapest? Thanks guys

 

You can get one @ gmperformanceparts.com...I have had good luck with centerfore dual/f with steel flywheel....Very good set up for bolt on car and then some...

 

I've got the Centerforce setup on eBay, if you decide to go with that.

 

what all does it include John Ceta??

 

For all your LS7 clutch needs see below

http://www.sdparts.com/product/SDLS7...ClutchKit.aspx

And the other parts

http://www.sdparts.com/catalog/lsgen...eelClutch.aspx

 

is this a pretty good and reliable site? Never ordered anything from here. I was looking for stuff on summitracing.com

 

how are the Exedy style clutches???

 

https://ls1tech.com/forums/showthrea...=480656&page=1

I'd personally choose the Textralia 0Z700 with a steel flywheel. I don't have one yet, but reviews show that everyone who has it likes it, it has a stock feel, and it has a decent longevity.

 

How much do they run?? Where can someone buy these at?

 

I've bought stuff from SDPC numerous times and their customer service is top notch. A great company to deal with

 

im probably going to end up buying the one from SDPC LS7 clutch kit for 399, do I still have to get a throw out bearing too?? Can ya get me a discount then Z28/2002?? hhaha thanks for all your help to

 

What about the LS6 ZO6 clutch kit from SDPC???? Anyone have that? or know something about it

 

The LS7 will hold better than the LS6. I had an LS6 in mine after the H/C swap and it took a **** after 300 miles

 

to revive the thread, if you buy the LS7 kit, is anything else needed for the install as asked, alignment tool, throw out bearing?

 

I just ordered my LS7 clutch kit from SDPC...quick shipping

 

You will need an alignment tool and it is a good idea to replace the throw out bearing while you are in there. Also, a new flywheel bolt kit wouldn't hurt. Also a good time to flush your hydraulics out and get some new fluid in there.

 

Ok I ordered my LS7 clutch kit today from SDPC, the 399 isnt on sale anymore, it was 438 or something like that, and they threw in a throw out bearing, blot kit, and the pilot bearing. They threw in all the parts for free and just charged me the clutch + tax. It was like 460 something shipped. Hope it works good!