Description:

Parting out my 2002 Camaro race car. Moving on to something different. Will haveT56 trans cross member that relocates the BMR torque arm also. Will also have a BMR Turbo K-member that will be listed soon. Need a few days.


*New Front bumper. Center has been cut out to allow free flow to intercooler and metal grill installed. Would rather not ship due to the size. $50
*New replacement fenders. Would rather not ship due to the size. $60 for both
*New. Never installed. Comes with brand new 180 degree thermostat. 1.5 inch inlet and outlet. $45 shipped
*New, never installed oil pressure sender unit. $10 shipped *SOLD*
*New, never installed Moog 234 U-Joint. $15 shipped
*New, never installed Trick Flow 4 corner steam vent kit P/N TFS-306SB601K $60 shipped
*New, never installed Meziere LS-1 Thermostat adapter outlet for electric water pump. $20 shipped
*Installed but never used Nitrous outlet dedicated fuel system. P/N 00-12050. No relay included. $500 shipped
*New, never installed Summit racing brake proportioning valve. $50 shipped
*New, never installed Meziere wiring kit with relay. $25 shipped *SOLD*
*New, Never installed Aerocatch 120 hood pin kit. $50 shipped
*Used WARR 92mm Throttle body. $100 shipped
*Holley Highram LS3 intake manifold with Nitrous Express direct port nitrous kit installed. Nitrous kit has never been used. Comes with 10 pound bottle with lightning valve that has never been filled. Comes with an automatic bottle warmer kit including the heater. Also comes with low fuel pressure safety switch and all jets. Also comes with a Dynotune Purge kit. Intake is painted wrinkle black. Has Holley fuel rails and LS3 injectors installed. Has 3 bar map sensor, Summit racing fuel pressure Gauge, Fuel line adapter to connect stock fuel line to Holley rail, and Holley fuel rail adjustable bracket which moves the fuel rail up or down depending on the injector you are running. Has NOS activation micro switch and bracket along with throttle cable bracket. Has all hardware and gaskets. Have over $2800 invested in this intake and nitrous setup. Asking $2000 plus shipping for all of it.
*T56 Center console with lid. Has switch installed under cigarette lighter for a line lock. You can use it for anything. has shift boot also but didn't get a picture of it. Don't want to ship due to size. $125

Added Parts. All parts are new and were only installed and never on the road. 0 milage on all this.
*BMR Manual brake conversion kit $120 shipped
*Tick Performance adjustable master cylinder $300 shipped
*ICT billet coil relocation brackets. $30 shipped
*BMR non-adjustable upper control arms $235 shipped
*BMR Adjustable chrome moly torque arm $400 shipped
*Monster Ceramic 11" Clutch kit $550 plus shipping
*BMR adjustable lower control arms $450 shipped
*ICT Billet Alternator relocation bracket and belt $50 shipped
*Built Texas Drivetrain Performance TR6060. Has oil sprayers installed and capped off ready to plumb a lube system. you will need a 31 spline yoke. Has Quicktime LS/T56 bell housing and MGW Short shifter. Has GM Throwout bearing with Tick remote blender installed. I have over $4500 invested in this setup. It is rated for over 1000hp. I will not take a dime less then $3500. shipped. I will just keep it. *SOLD*

More stuff coming as I get it off. Have a BMR turbo K member and more.




Paypal fees are not included. Thanks for your interest.