Fort Wayne Nasty's Bait Shop crowd
just joking Josh 
11-14-2007, 08:12 AM
#1726
Banned
iTrader: (2)
Join Date: Feb 2005
Location: LEO INDIANA
Posts: 2,261
Likes: 0
Received 0 Likes
on
0 Posts
hey nate ben does make a good point....i really miss my 03 vette but not as much as my prowler...i really miss that car alot....it was hard for me to sell that car..even though it made me 10k....you can ask todd i was up 10k on that car and still did not want to sell it....and looking back i wish i would of kept it....even though it was slow and rode like a dump truck it was just a cool car ....and i regrete selling it....i say yeh sell you 02 not that big of a deal..like selling my 07 no big deal....but hold on to the 95...that car goes back waaayyyy back.....just my 2 cents....
Last edited by kdogc5; 11-15-2007 at 05:17 PM.
11-16-2007, 11:26 PM
#1730
well, joe just got done degreeing my cam in, it's within a half degree. he says to run her.
pretty close to being right on the specs with a loose chain. now it's the hard part, ptv clearance with heads that have been milled .050, and a cam in the 230+ duration @.050 range and .600 lift.
pretty close to being right on the specs with a loose chain. now it's the hard part, ptv clearance with heads that have been milled .050, and a cam in the 230+ duration @.050 range and .600 lift. 
11-17-2007, 07:03 PM
#1732
http://www.powertvonline.com/video_detail.php?mId=2901
We were at the right place at the right time. Bob
We were at the right place at the right time. Bob
11-17-2007, 09:07 PM
#1733
http://www.powertvonline.com/video_detail.php?mId=2901
We were at the right place at the right time. Bob
We were at the right place at the right time. Bob
11-18-2007, 11:58 AM
#1736
well, joe just got done degreeing my cam in, it's within a half degree. he says to run her. pretty close to being right on the specs with a loose chain. now it's the hard part, ptv clearance with heads that have been milled .050, and a cam in the 230+ duration @.050 range and .600 lift.
pretty close to being right on the specs with a loose chain. now it's the hard part, ptv clearance with heads that have been milled .050, and a cam in the 230+ duration @.050 range and .600 lift.
. me and joe flycutted the intake side a little, to give ous more comfortable room.
11-18-2007, 12:03 PM
#1737
hey nate, give joe a hard time. we took him out saturday night and got him really trashed
, and he was actually ballin with some girls on the dance floor, and ended up leaving with one. he says this is very rare for him to do and only happens once every 5yrs. ha
, and he was actually ballin with some girls on the dance floor, and ended up leaving with one. he says this is very rare for him to do and only happens once every 5yrs. ha 
Never know, he might just move down here cause of it.